PROBLEM SYMPTOMS TABLE
Troubleshooting · Vehicles built Aug 2005 – Dec 2005
Versions by build date: Aug 2005 – Dec 2005 from Jan 2006
If no DTCs are displayed during the DTC check but the problem still occurs, check the circuits for each problem symptom in the order given in the table below and proceed to the relevant troubleshooting page.
- NOTICE:
- When replacing the brake actuator or sensor, turn the ignition switch off.
| Symptom |
Suspected area |
See page |
| ABS and/or EBD does not operate |
1. Check for DTCs again and make sure that normal system code displayed. |
Click here
|
| 2. IG power source circuit |
Click here
|
|
| 3. Front speed sensor circuit |
Click here
|
|
| 4. Skid control sensor circuit |
Click here
|
|
| 5. Check brake actuator using intelligent tester. (Check brake actuator operation using active test function.) If abnormal, check hydraulic circuit for leakage. |
Click here
|
|
| 6. If symptoms still occur even after above circuits in suspected areas inspected and proved to be normal, replace brake actuator (skid control ECU). |
Click here
|
|
| ABS and/or EBD does not operate efficiently |
1. Check for DTCs again and make sure that normal system code displayed. |
Click here
|
| 2. Front speed sensor circuit |
Click here
|
|
| 3. Skid control sensor circuit |
Click here
|
|
| 4. Stop light switch circuit |
Click here
|
|
| 5. Check brake actuator using intelligent tester. (Check brake actuator operation using active test function.) If abnormal, check hydraulic circuit for leakage. |
Click here
|
|
| 6. If symptoms still occur even after above circuits in suspected areas inspected and proved to be normal, replace brake actuator (skid control ECU). |
Click here
|
|
| Sensor signal check cannot be performed |
1. TS and CG terminal circuit |
Click here
|
| 2. Brake actuator (skid control ECU) |
Click here
|
|
| DTC check cannot be performed |
1. Check for DTCs again and make sure that normal system code displayed. |
Click here
|
| 2. TC and CG terminal circuit |
Click here
|
|
| 3. If symptoms still occur even after above circuits in suspected areas inspected and proved to be normal, replace brake actuator (skid control ECU). |
Click here
|
|
| ABS warning light remains on |
1. ABS warning light circuit |
Click here
|
| 2. Brake actuator (skid control ECU) |
Click here
|
|
| ABS warning light does not come on |
1. ABS warning light circuit |
Click here
|
| 2. Brake actuator (skid control ECU) |
Click here
|
|
| BRAKE warning light remains on |
1. BRAKE warning light circuit |
Click here
|
| 2. Brake actuator (skid control ECU) |
Click here
|
|
| BRAKE warning light does not come on |
1. BRAKE warning light circuit |
Click here
|
| 2. Brake actuator (skid control ECU) |
Click here
|