2005-2008 Yaris · Service Manual BODY ELECTRICAL

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Aug 2005 – Dec 2005

Versions by build date: Aug 2005 – Dec 2005 from Jan 2006

HINT:
In accordance with the following procedures, troubleshoot the audio and visual system.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard Voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.BASIC INSPECTION
    1. Turn the ignition switch on (ACC).

    2. Check whether the display appears on the radio receiver.

      Result
      Proceed to
      Display appears
      A
      Display does not appear
      B


    B.
    A

    4.DTC CHECK
    1. Check for DTCs and note any codes that are output.

    2. Delete the DTC(s).

    3. Recheck for DTCs after reproducing the symptoms that caused the DTCs noted in step (a) above.

      Result
      Proceed to
      Display does not appear
      A
      Display appears
      B


    B.
    A

    5.PROBLEM SYMPTOMS TABLE
      Result
      Proceed to
      Fault not listed in problem symptoms table
      A
      Fault listed in problem symptoms table
      B

    B.
    A

    6.OVERALL ANALYSIS AND TROUBLESHOOTING
    1. Terminals of ECU (Click here)

    2. Inspection (Click here, Click here, Click here, Click here)

    NEXT

    7.ADJUST, REPAIR OR REPLACE
      NEXT

      8.CONFIRMATION TEST
        NEXT

        ← SYSTEM DESCRIPTION (from Aug 2005)HOW TO PROCEED WITH TROUBLESHOOTING (from Jan 2006) →