HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Jan 2006
Versions by build date: Aug 2005 – Dec 2005 from Jan 2006
- HINT:
- In accordance with the following procedures, troubleshoot the audio and visual system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| NEXT |
|
 |
|
|
| 2.INSPECT BATTERY VOLTAGE |
- Standard Voltage:
- 11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| NEXT |
|
 |
|
|
Turn the ignition switch on (ACC).
Check whether the display appears on the radio receiver.
Result
|
Proceed to
|
Display appears
|
A
|
Display does not appear
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
Check for DTCs and note any codes that are output.
Delete the DTC(s).
Recheck for DTCs after reproducing the symptoms that caused the DTCs noted in step (a) above.
Result
|
Proceed to
|
Display does not appear
|
A
|
Display appears
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
Result
|
Proceed to
|
Fault not listed in problem symptoms table
|
A
|
Fault listed in problem symptoms table
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
| 6.OVERALL ANALYSIS AND TROUBLESHOOTING |
Terminals of ECU (Click here)
Inspection (Click here, Click here, Click here, Click here, Click here ,Click here)
| NEXT |
|
 |
|
|
| 7.ADJUST, REPAIR OR REPLACE |
| NEXT |
|
 |
|
|
| NEXT |
|
 |
|
|