2005-2008 Yaris · Service Manual TRANSMISSION

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Nov 2005


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
      NEXT

      3.CONNECT INTELLIGENT TESTER TO DLC3

        HINT:
        If the display indicates a communication fault in the tool, inspect the DLC3.

      NEXT

      4.CHECK CAN COMMUNICATION SYSTEM
      1. Check for output DTCs.

        HINT:
        The ECM of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, check that there is no trouble in the CAN communication system (Click here).


        Result:
        Display (DTC Output)
        Proceed To
        CAN communication system DTCs
        A
        No output
        B


      A.

      B.
      5.CHECK DTC AND FREEZE FRAME DATA

        NOTICE:
        Record or print DTCs and freeze frame data, if necessary. Refer to the relevant pages (Click here).

      NEXT

      6.CLEAR DTC AND FREEZE FRAME DATA

        HINT:
        Refer to the relevant pages (Click here).

      NEXT

      7.VISUAL INSPECTION
        NEXT

        8.PROBLEM SYMPTOM CONFIRMATION

          Result:
          Result
          Proceed To
          Symptom does not occur
          A
          Symptom occurs
          B


        A.

        B.
        9.SYMPTOM SIMULATION

          HINT:
          Refer to the relevant pages (Click here).

        NEXT

        10.DTC CHECK

          HINT:
          Refer to the relevant pages (Click here).


          Result:
          Display (DTC Output)
          Proceed To
          Output
          A
          No output
          B


        A.

        B.
        11.DTC CHART

          HINT:
          Refer to the relevant pages (Click here).

        NEXT

        12.PROBLEM SYMPTOMS TABLE

          HINT:
          Refer to the relevant pages (Click here).

        NEXT

        13.CIRCUIT INSPECTION

          HINT:
          Refer to the relevant pages (Click here).

        NEXT

        14.IDENTIFICATION OF PROBLEM
          NEXT

          15.ADJUSTMENT, REPAIR
            NEXT

            16.CONFIRMATION TEST
              NEXT

              ← SYSTEM DESCRIPTION (from Nov 2005)INITIALIZATION (from Nov 2005) →