HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Nov 2005
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
| |||||
| 3.CONNECT INTELLIGENT TESTER TO DLC3 |
- HINT:
- If the display indicates a communication fault in the tool, inspect the DLC3.
| |||||
| 4.CHECK CAN COMMUNICATION SYSTEM |
Check for output DTCs.
- Result:
Result
Proceed To
No CAN system DTC output
A
CAN system DTC output
B
- HINT:
- The ECM of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, check that there is no trouble in the CAN communication system (Click here).
|
|||||
| |||||
| 5.CHECK DTC AND FREEZE FRAME DATA |
- NOTICE:
- Record or print DTCs and freeze frame data, if necessary. Refer to the relevant pages (Click here).
| |||||
| 6.CLEAR DTC AND FREEZE FRAME DATA |
- HINT:
- Refer to the relevant pages (Click here).
| |||||
| 7.VISUAL INSPECTION |
| |||||
| 8.PROBLEM SYMPTOM CONFIRMATION |
- Result:
Result
Proceed To
Symptom does not occur
A
Symptom occurs
B
|
|||||
| |||||
| 9.SYMPTOM SIMULATION |
- HINT:
- Refer to the relevant pages (Click here).
| |||||
| 10.DTC CHECK |
- Result:
Result
Proceed To
DTC output
A
No DTC output
B
- HINT:
- Refer to the relevant pages (Click here).
|
|||||
| |||||
| 11.DTC CHART |
- HINT:
- Refer to the relevant pages (Click here).
| |||||
| 12.PROBLEM SYMPTOMS TABLE |
- HINT:
- Refer to the relevant pages (Click here).
| |||||
| 13.CIRCUIT INSPECTION |
- HINT:
- Refer to the relevant pages (Click here).
| |||||
| 14.IDENTIFICATION OF PROBLEM |
| |||||
| 15.ADJUSTMENT, REPAIR |
| |||||
| 16.CONFIRMATION TEST |
| |||||