2005-2008 Yaris · Service Manual TRANSMISSION

DIAGNOSTIC TROUBLE CODE CHART

Diagnostic trouble codes · Vehicles built from Nov 2005

HINT:
If a trouble codes is displayed during the DTC check, check the circuit indicated by the DTC. For details of each code, refer to the page for the respective "DTC No." in the DTC chart.
Inspect the "Fuse" and "Relay" before inspecting the suspected areas as shown in the chart below.

*1: Multi-mode Manual Transmission Warning Light
Diagnostic Trouble Code Chart 
DTC No.
Detection Item
Trouble Area
MIL
Warning Light (*1)
Memory
See page
P0500
Vehicle Speed Sensor "A"
1. Open or short in speed signal circuit
2. Combination meter
3. Speed sensor (Brake control system)
4. Skid control ECU (Brake control system)
5. Transmission control ECU
-
Comes on
DTC stored
Click here
P0562
System Voltage
1. Open or short in power source circuit
2. Transmission control ECU
Comes on
Comes on
DTC stored
Click here
P0603
Internal Control Module Keep Alive Memory (KAM) Error
1. Transmission control ECU
-
Comes on
DTC stored
Click here
P0613
TCM Processor
1. Transmission control ECU
-
Comes on
-
Click here
P0703
Brake Switch "B" Circuit
1. Open or short in STP or ST1- signal circuits
2. Stop light switch assembly
3. Transmission control ECU
-
Comes on
DTC stored
Click here
P0715
Input / Turbine Speed Sensor Circuit Malfunction
1. Open or short in transmission revolution sensor circuit
2. Transmission revolution sensor
3. Transmission control ECU
-
Comes on
DTC stored
Click here
P0725
Engine Speed Input Circuit
1. Open or short in NE signal circuit
2. Transmission control ECU
3. ECM
-
Comes on
DTC stored
Click here
P0806
Clutch Position Sensor Circuit (Range / Performance)
1. Clutch stroke sensor
2. Open or short in clutch stroke sensor circuit
3. Transmission control ECU
-
Comes on
DTC stored
Click here
P0807
Clutch Position Sensor (Low)
1. Clutch stroke sensor
2. Open or short in clutch stroke sensor circuit
3. Transmission control ECU
Comes on
Comes on
DTC stored
Click here
P0808
Clutch Position Sensor (High)
1. Clutch stroke sensor
2. Open or short in clutch stroke sensor circuit
3. Transmission control ECU
Comes on
Comes on
DTC stored
Click here
P0810
Clutch Position Control Error
1. Clutch actuator assembly (clutch motor)
2. Clutch mechanical system (clutch cover, clutch disc, release fork, release bearing)
3. Clutch stroke sensor
4. Transmission control ECU
-
Comes on
DTC stored
Click here
P0812
Reverse Input Circuit
1. Shift stroke sensor
2. Select stroke sensor
3. Back up light switch assembly
4. Open or short in back up light switch circuit
5. Transmission control ECU
-
Comes on
DTC stored
Click here
P0820
Gear Lever "X-Y" Position Sensor Circuit
1. Shift lever position sensor
2. Open or short in shift lever position signal circuit
3. Transmission control ECU
-
Comes on
DTC stored
Click here
P0821
Gear Lever "X" Position Circuit
1. Transmission shift main switch (built into shift lever assembly
2. Short in MDSW signal circuit
3. Transmission control ECU
-
Comes on
DTC stored
Click here
P0885
TCM Power Relay Control Circuit (Open)
1. AMT fuse
2. AMT relay
3. Open in MREL signal circuit
4. Open in PGND signal circuit
5. Opne in +BM signal circuit
6. Transmission control ECU
-
Comes on
DTC stored
Click here
P0887
TCM Power Relay Control Circuit (Short)
1. AMT relay
2. Short in MREL signal circuit
3. Short in PGND signal circuit
4. Short in +BM signal circuit
5. Transmission control ECU
-
Comes on
DTC stored
Click here
P0900
Clutch Actuator Circuit
1. Clutch actuator assembly (clutch motor)
2. Open or short in clutch motor circuit
3. Transmission control ECU
-
Comes on
DTC stored
Click here
P0905
Gate Select Position Circuit (Range / Performance)
1. Select stroke sensor
2. Open or short in select stroke sensor circuit
3. Transmission control ECU
-
Comes on
DTC stored
Click here
P0906
Gate Select Position Circuit (Low)
1. Select stroke sensor
2. Open or short in select stroke sensor circuit
3. Transmission control ECU
Comes on
Comes on
DTC stored
Click here
P0907
Gate Select Position Circuit (High)
1. Select stroke sensor
2. Open or short in select stroke sensor circuit
3. Transmission control ECU
Comes on
Comes on
DTC stored
Click here
P0909
Gate Select Control Error
1. Select stroke sensor
2. Shift and select actuator assembly (select motor)
3. Transmission control ECU
4. Shift head or shift fork shaft (built into transmission assembly)
-
Comes on
DTC stored
Click here
P0910
Gate Select Actuator Circuit
1. Shift and select actuator assembly (select motor)
2. Open or short in select motor circuit
3. Transmission control ECU
-
Comes on
DTC stored
Click here
P0915
Gear Shift Position Circuit (Range / Performance)
1. Shift stroke sensor
2. Open or short in shift stroke sensor circuit
3. Transmission control ECU
-
Comes on
DTC stored
Click here
P0916
Gear Shift Position Circuit (Low)
1. Shift stroke sensor
2. Open or short in shift stroke sensor circuit
3. Transmission control ECU
Comes on
Comes on
DTC stored
Click here
P0917
Gear Shift Position Circuit (High)
1. Shift stroke sensor
2. Open or short in shift stroke sensor circuit
3. Transmission control ECU
Comes on
Comes on
DTC stored
Click here
P0919
Gear Shift Position Control Error
1. Shift stroke sensor
2. Shift and select actuator assembly (shift motor)
3. Transmission control ECU
4. Transmission assembly
-
Comes on
DTC stored
Click here
P0920
Gear Shift Forward Actuator Circuit
1. Shift and select actuator assembly (shift motor)
2. Open or short in shift motor circuit
3. Transmission control ECU
-
Comes on
DTC stored
Click here
P1875
Buzzer Malfunction
1. Transmission control ECU
-
Comes on
DTC stored
Click here
U0100
Lost Communication with ECM/PCM "A"
1. Open or short in CAN signal circuit
2. ECM
3. Transmission control ECU
Comes on
Comes on
DTC stored
Click here
← DATA LIST / ACTIVE TEST (from Nov 2005)ADJUSTMENT (from Nov 2005) →