P2119 Throttle Actuator Control Throttle Body Range / Performance
Diagnostic trouble codes · Vehicles built from Aug 2005
DESCRIPTION
The throttle actuator is operated by the ECM, and opens and closes the throttle valve using gears. The opening angle of the throttle valve is detected by the Throttle Position (TP) sensor, which is mounted on the throttle body. The TP sensor provides feedback to the ECM in order that it can control the throttle actuator, and therefore the throttle valve, appropriately in response to driver inputs.- HINT:
- This ETCS (Electronic Throttle Control System) does not use a throttle cable.
| DTC No. |
DTC Detection Condition |
Trouble Aria |
| P2119 |
After P2112 is detected, the throttle does not close when the current to the throttle motor is cut off. (1 trip detection logic) |
Throttle body assembly |
- HINT:
- Detection for P2119 is performed during electronic throttle learning.
INSPECTION PROCEDURE
- HINT:
- Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data, from the time the malfunction occurred.
| 1. CHECK THROTTLE BODY ASSEMBLY (VISUALLY CHECK THROTTLE VALVE) |
Check for contamination between the throttle valve and the housing, and check that the throttle valve moves smoothly.
- OK:
- No contamination between the throttle valve and the housing, and the throttle valve moves smoothly.
|
|
||||
| OK | |
| 2. REPLACE THROTTLE BODY ASSEMBLY |
Replace the throttle body assembly (Click here).
Perform electronic throttle learning (Click here).
| NEXT | ||
| ||
