2005-2008 Yaris · Service Manual STEERING

DIAGNOSTIC TROUBLE CODE CHART

Diagnostic trouble codes · Vehicles built Aug 2005 – Dec 2005

Versions by build date: Aug 2005 – Dec 2005 from Jan 2006

HINT:
If any DTCs are displayed during the DTC check, inspect the circuit listed for those DTCs. For details of each DTC, refer to the page indicated in the DTC chart.

DTC No.
Detection Item
Trouble Areas
Normal Return
P/S Warning Light
See page
C1511/11
Torque Sensor Circuit Malfunction
  1. Steering column assembly (Torque sensor)
  2. Power steering ECU
Ignition switch on (IG) again
○
Click here
C1512/12
Torque Sensor Circuit Malfunction
  1. Steering column assembly (Torque sensor)
  2. Power steering ECU
Ignition switch on (IG) again
○
Click here
C1513/13
Torque Sensor Circuit Malfunction
  1. Steering column assembly (Torque sensor)
  2. Power steering ECU
Ignition switch on (IG) again
○
Click here
C1514/14
Torque Sensor Power Source Circuit Malfunction
  1. Steering column assembly (Torque sensor)
  2. Power steering ECU
Ignition switch on (IG) again
○
Click here
C1515/15
Torque Sensor Zero Point Adjustment is not Initialized
  1. Torque sensor zero point calibration not performed
  2. Steering column assembly
After calibrating torque sensor zero point
○
Click here
C1516/16
Torque Sensor Zero Point Adjustment Incomplete
  1. Torque sensor zero point calibration failure
  2. Steering column assembly
After calibrating torque sensor zero point normally
○
Click here
C1517/17
Torque Sensor Hold Malfunction
  1. Steering column assembly (Torque sensor)
  2. Power steering ECU
Ignition switch on (IG) again
○
Click here
C1524/24
Motor Circuit Malfunction
  1. Steering column assembly
  2. Power steering ECU
Ignition switch on (IG) again
○
Click here
C1531/31
EPS ECU Circuit Malfunction
  1. Power steering ECU
Ignition switch on (IG) again
○
Click here
C1532/32
EPS ECU Circuit Malfunction
  1. Power steering ECU
Ignition switch on (IG) again
○
Click here
C1533/33
EPS ECU Circuit Malfunction
  1. Power steering ECU
Ignition switch on (IG) again
○
Click here
C1534/34
EPS ECU Circuit Malfunction
  1. Power steering ECU
Ignition switch on (IG) again
-
Click here
C1551/51
IG Power Source Circuit Malfunction
  1. ECU-IG fuse
  2. IG power source circuit
  3. Power steering ECU
Ignition switch on (IG) again or after normal confirmation
○
Click here
C1552/52
PIG Power Source Circuit
  1. EPS fuse
  2. PIG power source circuit
  3. Power steering ECU
Ignition switch on (IG) again or after normal confirmation
○
Click here
C1554/54
EPS Relay Circuit
  1. EPS fuse
  2. PIG power source circuit
  3. Power steering ECU
Ignition switch on (IG) again
○
Click here
C1555/55
EPS Motor Relay Circuit
  1. Power steering ECU
  2. Steering column assembly (Power steering motor)
Ignition switch on (IG) again
○
Click here
U0073
Control Module Communication Bus OFF
  1. CAN communication system
Ignition switch on (IG) again or after normal confirmation
○
Click here
U0105
Lost Communication with ECM
  1. CAN communication system
  2. ECM
Ignition switch on (IG) again or after normal confirmation
○
Click here
U0121
Lost Communication with Anti-lock Brake System (ABS) Control Module
  1. CAN communication system
  2. Skid control ECU
Ignition switch on (IG) again or after normal confirmation
○
Click here
(Warning light) ○---turn on, X---turn off (Normal reset)
← DATA LIST / ACTIVE TEST (from Aug 2005)DIAGNOSTIC TROUBLE CODE CHART (from Jan 2006) →