2005-2008 Yaris · Service Manual RESTRAINTS

B1662/45 Indicator Light Circuit Malfunction

Diagnostic trouble codes · Vehicles built Aug 2005 – Dec 2005

Versions by build date: Aug 2005 – Dec 2005 from Jan 2006

DESCRIPTION

The indicator light circuit consists of the center airbag sensor assembly and the combination meter. DTC B1662/45 is set when a malfunction is detected in the indicator light circuit.
DTC No.
DTC Detecting Conditions
Trouble Areas
B1662/45
  1. Center airbag sensor assembly detects line short circuit signal, open circuit signal, short circuit to ground signal or short circuit to B+ signal in indicator light circuit for 2 seconds
  2. Indicator light circuit malfunction
  3. Center airbag sensor assembly malfunction
  1. Instrument panel wire
  2. Combination meter
  3. Center airbag sensor assembly

WIRING DIAGRAM

H100185E02
H100186E02
H102131E01

INSPECTION PROCEDURE

NOTICE:
In order to prevent unexpected airbag deployment, disconnect the following connectors before inspecting parts such as wire harnesses, if the application of tester probes to the center airbag sensor assembly connector is necessary.

  1. Turn the ignition switch off.
  2. Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
  3. Disconnect the connector from the center airbag sensor assembly.
  4. Disconnect the connector from the steering pad.
  5. Disconnect the connector from the front seat outer belt assembly LH.
  6. Disconnect the connector from the front seat outer belt assembly RH.

    HINT:
    Skip the following steps if side airbags, curtain shield airbags, front passenger airbag and a knee airbag are not fitted.

  7. Disconnect the connector from the front passenger airbag assembly.
  8. Disconnect the connector from the front seat side airbag assembly LH.
  9. Disconnect the connector from the front seat side airbag assembly RH.
  10. Disconnect the connector from the curtain shield airbag assembly LH.
  11. Disconnect the connector from the curtain shield airbag assembly RH.
  12. Disconnect the connector from the driver side knee airbag assembly.

1. CHECK DTC (AIRBAG SYSTEM)
  1. Turn the ignition switch on (IG).

  1. Clear the DTCs stored in the memory (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch on (IG) and wait for at least 60 seconds.

  1. Check the DTCs (Click here).

    OK:
    DTC B1662/45 is not output.

    HINT:
    DTCs other than B1662/45 may be output at this time, but they are not related to this check.



OK
USE SIMULATION METHOD TO CHECK
NG


2. CHECK DTC (CAN COMMUNICATION SYSTEM)
  1. Turn the ignition switch on (IG).

  1. Check the DTCs (Click here).

    OK:
    DTC is not output.



NG
CHECK CAN COMMUNICATION SYSTEM
OK


3. CHECK CONNECTION OF CONNECTORS
  1. Turn the ignition switch off.

  1. Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.

  1. Check that the connectors are properly connected to the center airbag sensor assembly and the combination meter.

    OK:
    The connectors are properly connected.



NG
CONNECT CONNECTORS
OK


4. CHECK CENTER AIRBAG SENSOR ASSEMBLY
H100897E01
  1. Turn the ignition switch off.

  1. Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.

  1. Replace the center airbag sensor assembly (Click here).

    HINT:
    Perform the inspection using parts from a normal vehicle when possible.

  1. Connect the connectors to the center airbag sensor assembly and the combination meter.

  1. Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.

  1. Turn the ignition switch on (IG), and wait for at least 60 seconds.

  1. Clear the DTCs stored in the memory (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch on (IG), and wait for at least 60 seconds.

  1. Check for DTCs (Click here).

    OK:
    DTC B1662/45 is not output.

    HINT:
    DTCs other than B1662/45 may be output at this time, but they are not related to this check.



NG
GO TO METER / GAUGE SYSTEM
OK

END


← B1660/43 Passenger Airbag OFF Indicator Circuit Malfunction (from Aug 2005)B1662/45 Indicator Light Circuit Malfunction (from Jan 2006) →