2005-2008 Yaris · Service Manual ENGINE

MIL Circuit

Circuit diagnosis · Vehicles built from Aug 2005

DESCRIPTION

The MIL (Malfunction Indicator Lamp) is used to indicate vehicle malfunction detections by the ECM. By turning the ignition switch on (IG), power is supplied to the MIL circuit, and the ECM provides the circuit ground which illuminates the MIL.
The MIL operation can be checked visually: When the ignition switch is first turned on (IG), the MIL illuminates and then goes off. If the MIL remains illuminated or is not illuminated, conduct the following troubleshooting procedure using an intelligent tester.

WIRING DIAGRAM

A109137E02

INSPECTION PROCEDURE

NOTICE:
Perform electronic throttle learning after replacing the ECM (Click here).


1. CHECK MIL CONDITION
  1. Perform troubleshooting in accordance with the chart below.

    Result:
    MIL Condition
    Proceed to
    MIL remains ON
    A
    MIL does not illuminate
    B



B
Go to step 4
A


2. CHECK WHETHER MIL GOES OFF
  1. Connect an intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Turn the tester ON.

  1. Check whether any DTCs have been stored (Click here). Note them down if necessary.

  1. Clear DTCs (Click here).

  1. Check if the MIL goes off.

    OK:
    MIL goes off.



OK
REPAIR CIRCUIT INDICATED BY OUTPUT DTC
NG


3. CHECK HARNESS AND CONNECTOR
A116134E05
  1. Disconnect the ECM connector.

  1. Turn the ignition switch on (IG).

  1. Check that MIL is not illuminated.

    OK:
    MIL is not illuminated.

  1. Reconnect the ECM connector.



NG
CHECK HARNESS AND CONNECTOR (ECM - COMBINATION METER)
OK

REPLACE ECM

4. CHECK THAT MIL IS ILLUMINATED
  1. Check if the MIL illuminates when turning the ignition switch on (IG).

    OK:
    MIL illuminates.



OK
END
NG


5. CHECK THAT ENGINE STARTS
  1. Turn the ignition switch on (IG).

  1. Check whether the engine starts

    Result:
    Engine Condition
    Proceed To
    Engine starts
    A
    Engine does not start
    B

    HINT:
    *: The intelligent tester cannot communicate with the ECM.



B
GO TO VC OUTPUT CIRCUIT
A


6. INSPECT COMBINATION METER ASSEMBLY (MIL CIRCUIT)
  1. See the combination meter troubleshooting procedure (Click here).

    OK:
    MIL illuminates



NG
REPAIR OR REPLACE COMBINATION METER ASSEMBLY
OK

CHECK AND REPLACE HARNESS AND CONNECTOR (COMBINATION METER - ECM)


← Cranking Holding Function Circuit (from Aug 2005)COMPONENTS (from Aug 2005) →