2005-2008 Yaris · Service Manual BRAKE

C1210/36 Zero Point Calibration of Yaw Rate Sensor Undone

Diagnostic trouble codes · Vehicles built from Aug 2005

Also covers:

DESCRIPTION

The ABS and TRACTION actuator receives signals from the yaw rate and deceleration sensor via the CAN communication system. The yaw rate sensor has a built-in deceleration sensor and detects the vehicle's condition using 2 circuits (GL1, GL2). If there are problems in the bus lines between the yaw rate and deceleration sensor and the CAN communication system, DTCs U0123/62 (yaw rate sensor communication trouble) and U0124/95 (deceleration sensor communication trouble) are output. The DTCs are also output when the calibration has not been completed.
DTC No.
DTC Detecting Conditions
Trouble Areas
C1210/36
Zero point calibration of yaw rate sensor not completed.
  1. ABS and TRACTION actuator (skid control ECU)
  2. Zero point calibration incomplete
C1336/39
When either of following conditions (1 or 2) detected:
  1. Vehicle driven without completion of zero point calibration.
  2. After zero point has been obtained, zero point voltage of sensor not between 2.38 V and 2.62 V.
  1. ABS and TRACTION actuator (skid control ECU)
  2. Zero point calibration incomplete

WIRING DIAGRAM

E132583E01
C120357E02

INSPECTION PROCEDURE

NOTICE:
When replacing the ABS and TRACTION actuator, perform the zero point calibration (Click here).

HINT:
When U0123/62, U0124/95 or U0126/63 is output together with C1210/36 or C1336/39, inspect and repair trouble areas indicated by U0123/62, U0124/95 or U0126/63 first.


1. CHECK YAW RATE SENSOR INSTALLATION
  1. Check that the yaw rate sensor has been installed properly (Click here).

    OK:
    The sensor is tightened to the specified torque.
    The sensor is not tilted.



NG
INSTALL YAW RATE SENSOR CORRECTLY
OK


2. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION
  1. Perform zero point calibration of the yaw rate and deceleration sensor (Click here).


NEXT


3. RECONFIRM DTC
  1. Clear the DTC(s) (Click here).

  1. Start the engine.

  1. Drive the vehicle and turn the steering wheel to the right and left at a speed of 45 km/h (28 mph) or more.

  1. Check if the same DTC(s) is recorded (Click here).

    Result
    Proceed to
    DTC output
    A
    DTC not output
    B

    HINT:
    1. The DTC(s) is set if the zero point calibration has not been completed successfully.
    2. End the procedure when the same DTC(s) is not set after completion of the zero point calibration.



B
END
A

REPLACE ABS AND TRACTION ACTUATOR


← C1203/53 ECM Communication Circuit Malfunction (from Aug 2005)C1223/43 ABS Control System Malfunction (from Aug 2005) →