2005-2008 Yaris · Service Manual BRAKE

VSC Warning Light does not Come ON

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

Click here.

WIRING DIAGRAM

Click here.

INSPECTION PROCEDURE

NOTICE:
When replacing the ABS and TRACTION actuator, perform the zero point calibration (Click here).


1. INSPECT CAN COMMUNICATION SYSTEM
  1. Check if the CAN communication system DTC is output (Click here).

    Result:
    Result
    Proceed to
    DTC not output
    A
    DTC output
    B



B
REPAIR CAN COMMUNICATION SYSTEM
A


2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Start the engine.

  1. Select the "VSC Warning Lamp" in the ACTIVE TEST and operate the VSC warning light using the intelligent tester.

    ACTIVE TEST: ABS/VSC/TRC 
    Item (Display)
    Test Details
    Diagnostic Note
    VSC Warning Lamp
    Turn VSC warning light ON / OFF
    Observe combination meter

  1. Check that the VSC warning light turns on and off in the combination meter using the intelligent tester.

    OK:
    The VSC warning light turns ON and OFF in accordance with the intelligent tester operation.



NG
INSPECT COMBINATION METER
OK

REPLACE ABS AND TRACTION ACTUATOR

3. INSPECT COMBINATION METER
  1. Inspect the combination meter assembly (Click here).



NG
REPLACE COMBINATION METER
OK

REPLACE ABS AND TRACTION ACTUATOR


← VSC Warning Light Remains ON (from Nov 2005)Brake Warning Light Remains ON (from Nov 2005) →