2005-2008 Yaris · Service Manual BRAKE

Slip Indicator Light does not Come ON

Circuit diagnosis · Vehicles built from Aug 2005

DESCRIPTION

Click here.

WIRING DIAGRAM

Click here.

INSPECTION PROCEDURE

NOTICE:
When replacing the ABS and TRACTION actuator, perform the zero point calibration (Click here).


1. INSPECT CAN COMMUNICATION SYSTEM
  1. Check if the CAN communication system DTC is output (Click here).

    Result
    Proceed to
    DTC not output
    A
    DTC output
    B



B
REPAIR CAN COMMUNICATION SYSTEM
A


2. CHECK SLIP INDICATOR LIGHT
  1. Connect the intelligent tester to the DLC3.

  1. Turn the tester on.

  1. Select the "SLIP Indicator Lamp" in the ACTIVE TEST and operate the SLIP indicator light using the intelligent tester.

    ACTIVE TEST: ABS/VSC/TRC 
    Item (Display)
    Test Details
    Diagnostic Note
    SLIP Indicator Lamp
    Turn SLIP indicator light ON / OFF
    Observe combination meter

  1. Check that the SLIP indicator light turns on and off in the combination meter using the intelligent tester.

    OK:
    The SLIP indicator light turns ON and OFF in accordance with the intelligent tester operation.



NG
Go to step 3
OK

REPLACE ABS AND TRACTION ACTUATOR

3. INSPECT COMBINATION METER
  1. Inspect the combination meter (Click here).



NG
REPLACE COMBINATION METER
OK

REPLACE ABS AND TRACTION ACTUATOR


← Slip Indicator Light Remains ON (from Aug 2005)Skid Control Buzzer Circuit (from Aug 2005) →