Slip Indicator Light does not Come ON
Circuit diagnosis · Vehicles built from Nov 2005
DESCRIPTION
Click here.WIRING DIAGRAM
Click here.INSPECTION PROCEDURE
- NOTICE:
- When replacing the ABS and TRACTION actuator, perform the zero point calibration (Click here).
| 1. INSPECT CAN COMMUNICATION SYSTEM |
Check if the CAN communication system DTC is output (Click here).
- Result:
Result
Proceed to
DTC not output
A
DTC output
B
|
|
||||
| A | |
| 2. CHECK SLIP INDICATOR LIGHT |
Connect the intelligent tester to the DLC3.

Turn the ignition switch on.
Turn the tester on.
Select the "SLIP Indicator Lamp" in the ACTIVE TEST and operate the SLIP indicator light using the intelligent tester.
ACTIVE TEST: ABS/VSC/TRC Item (Display)
Test Details
Diagnostic Note
SLIP Indicator Lamp
Turn SLIP indicator light ON / OFF
Observe combination meter
Check that the SLIP indicator light turns on and off in the combination meter using the intelligent tester.
- OK:
- The SLIP indicator light turns ON and OFF in accordance with the intelligent tester operation.
|
|
||||
| OK | ||
| ||
| 3. INSPECT COMBINATION METER |
Inspect the combination meter (Click here).
|
|
||||
| OK | ||
| ||
