2005-2008 Yaris · Service Manual BRAKE

C1290/66 Steering Angle Sensor Zero Point Malfunction

Diagnostic trouble codes · Vehicles built from Nov 2005

DESCRIPTION

DTC No.
Detecting Condition
Trouble Areas
C1290/66
Steering angle sensor zero point deviates from zero point stored in skid control ECU by 20 degrees or more.
  1. Steering angle sensor
  2. Steering angle sensor circuit
  3. CAN communication system

WIRING DIAGRAM

Click here.

INSPECTION PROCEDURE

NOTICE:
When replacing the ABS and TRACTION actuator, perform zero point calibration (Click here).


1. DISCONNECT BATTERY NEGATIVE TERMINAL
  1. Disconnect the battery negative terminal to clear the steering angle sensor zero point.


NEXT


2. PERFORM STEERING ANGLE SENSOR ZERO POINT CALIBRATION
  1. Drive the vehicle at a speed of 15 km/h (9 mph) or more (zero point is obtained automatically).


NEXT


3. RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Check if the same DTC is recorded (Click here).

    Result:
    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
END
A


4. REPLACE STEERING ANGLE SENSOR
  1. Replace the steering angle sensor (Click here).


NEXT


5. RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Check if the same DTC is recorded (Click here).

    Result:
    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
END
A

REPLACE ABS AND TRACTION ACTUATOR


← C1251/51 Open in Pump Motor Circuit (from Nov 2005)C1300/62 Skid Control ECU Malfunction (from Nov 2005) →