VEHICLE STABILITY CONTROL SYSTEM > DIAGNOSIS SYSTEM |
| DESCRIPTION |
Check the battery voltage.
Check the DLC3 (Click here).
| DIAGNOSIS |
If the skid control ECU detects a malfunction, the ABS warning, brake warning, SLIP indicator lights will come on in order to warn the driver.
The DTCs are simultaneously stored in the memory. The DTCs can be read by connecting the SST between terminals TC and CG of the DLC3 and observing the blinking pattern of the ABS warning and SLIP indicator lights, or by connecting an intelligent tester.
This system has a Test Mode (signal check) function (Click here).
| WARNING LIGHT AND INDICATOR LIGHT INITIAL CHECK |
Release the parking brake.
When the ignition switch is turned to ON, check that the ABS warning, brake warning, TRC OFF indicator, VSC OFF indicator and SLIP indicator lights come on for approximately 3 seconds.
| Trouble Area | See procedure |
| ABS warning light circuit (Remains on) |
Click here
|
| ABS warning light circuit (Does not come on) |
Click here
|
| Brake warning light circuit (Remains on) |
Click here
|
| Brake warning light circuit (Does not come on) |
Click here
|
| TRC OFF indicator light circuit (Remains on) |
Click here
|
| TRC OFF indicator light circuit (Does not come on) |
Click here
|
| VSC OFF indicator light circuit (Remains on) |
Click here
|
| VSC OFF indicator light circuit (Does not come on) |
Click here
|
| SLIP indicator light circuit (Remains on) |
Click here
|
| SLIP indicator light circuit (Does not come on) |
Click here
|