VEHICLE STABILITY CONTROL SYSTEM (for Separate Type Yaw Rate Sensor) > DIAGNOSIS SYSTEM |
| DESCRIPTION |
Check the battery voltage.
Check the DLC3 (Click here).
| DIAGNOSIS |
If the skid control ECU (brake actuator assembly) detects a malfunction, the ABS warning, brake warning, Slip indicator will come on in order to warn the driver.
The DTCs are simultaneously stored in memory. The DTCs can be read by connecting SST between terminals TC and CG of the DLC3 and observing the blinking pattern of the ABS warning and Slip indicator lights, or by connecting the intelligent tester (Click here).
This system has a Test Mode (signal check) function (Click here).
| WARNING LIGHT AND INDICATOR LIGHT INITIAL CHECK |
Release the parking brake.
When the ignition switch is turned to ON, check that the ABS warning, brake warning, VSC OFF indicator, TRC OFF indicator, and Slip indicator lights come on for approximately 3 seconds.
| Trouble Area | See procedure |
| ABS warning light circuit (Remains on) |
Click here
|
| ABS warning light circuit (Does not come on) |
Click here
|
| Brake warning light circuit (Remains on) |
Click here
|
| Brake warning light circuit (Does not come on) |
Click here
|
| TRC OFF indicator light circuit (Remains on) |
Click here
|
| TRC OFF indicator light circuit (Does not come on) |
Click here
|
| VSC OFF indicator light circuit (Remains on) |
Click here
|
| VSC OFF indicator light circuit (Does not come on) |
Click here
|
| Slip indicator light circuit (Remains on) |
Click here
|
| Slip indicator light circuit (Does not come on) |
Click here
|