| Last Modified: 11-27-2007 | 1.6 S | |
| Service Category: Steering | Section: Steering Column | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000000XOD00IX |
| Title: VARIABLE GEAR RATIO STEERING: VARIABLE GEAR RATIO STEERING SYSTEM: DIAGNOSTIC TROUBLE CODE CHART (2008 LX570) | ||
DIAGNOSTIC TROUBLE CODE CHART
HINT:
If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below.
|
DTC Code |
Detection Item |
Trouble Area |
See page |
|---|---|---|---|
|
C1591/51 |
Actuator Neutral Position Calibration Undone |
There is no malfunction if this DTC is not output again after performing VGRS system calibration |
|
|
C1592/52 |
Actuator Neutral Position Calibration Incomplete |
- Steering actuator - Steering control ECU |
|
|
C1593/53 |
Actuator Standard Position Malfunction |
Steering actuator |
|
|
C1595/55 |
Lost Communication with Steering Angle Sensor Module |
- Steering angle sensor - Steering control ECU - Harness or connector |
|
|
C15A1/61 |
Actuator Malfunction |
- Harness or connector - Steering actuator - Steering control ECU |
|
|
C15A2/62 |
Actuator Malfunction |
- Harness or connector - Power source circuit - Steering actuator - Steering control ECU |
|
|
C15A3/63 |
Actuator Malfunction |
- Harness or connector - Steering actuator - Steering control ECU |
|
|
C15A4/64 |
Actuator Malfunction |
Steering actuator |
|
|
C15A5/65 |
Actuator Malfunction |
- Harness or connector - Steering actuator - Steering control ECU |
|
|
C15A6/62 |
Actuator Malfunction |
- Power source circuit - Harness or connector - Steering actuator - Steering control ECU |
|
|
C15A9/66 |
Lock Holder Deviation Detection |
Steering actuator |
|
|
C15AA/66 |
Lock Mechanism Release Incomplete |
Steering actuator |
|
|
C15AB/66 |
Lock Mechanism Insertion Malfunction |
Steering actuator |
|
|
C15B1/71 |
ECU Malfunction |
Steering control ECU |
|
|
C15B2/72 |
ECU Malfunction |
Steering control ECU |
|
|
C15B3/73 |
ECU Malfunction |
Steering control ECU |
|
|
C15B4/71 |
ECU Malfunction |
Steering control ECU |
|
|
C15C1/74 |
Steering Angle Sensor Malfunction |
- Steering angle sensor - Harness or connector - CAN communication system - Steering control ECU |
|
|
C15C2/74 |
Steering Angle Sensor B+ Malfunction |
- Steering angle sensor - Harness or connector - CAN communication system - Steering control ECU |
|
|
C15C3/75 |
Brake System Control Module Malfunction |
- Vehicle stability control system - CAN communication system - Steering control ECU |
|
|
C15C4/68 |
Steering Angle Signal (Test Mode DTC) |
- Steering angle sensor - Steering control ECU - Harness or connector |
|
|
C15C5/69 |
Motor Revolution Angle Signal (Test Mode DTC) |
- Harness or connector - Steering actuator - Steering control ECU |
|
|
C15C6/77 |
IG Power Supply Voltage Malfunction |
- Harness or connector - Steering control ECU |
|
|
C15C7/78 |
DC Motor Power Source Voltage Malfunction |
- Harness or connector - Steering control ECU |
|
|
C15C8/79 |
Power Supply Relay Failure |
- Harness or connector - Steering control ECU |
|
|
U0100/56 |
Lost Communication with ECM / PCM "A" |
- CAN communication system - ECM |
|
|
U0122/56 |
Lost Communication with Vehicle Dynamics Control Module |
-CAN communication system -Skid control ECU |
|
|
U0126/56 |
Lost Communication with Steering Angle Sensor Module |
- CAN communication system - Steering angle sensor |
|
|
|