| Last Modified: 11-27-2007 | 1.6 A | |
| Service Category: Power Source/Network | Section: Battery/Charging | |
| Model Year: 2008 | Model: LX570 | Doc ID: RM000002BS400QX |
| Title: 3UR-FE BATTERY / CHARGING: GENERATOR: REMOVAL (2008 LX570) | ||
REMOVAL
1. REMOVE ENGINE ROOM SIDE COVER LH
2. REMOVE ENGINE ROOM SIDE COVER RH
3. REMOVE UPPER RADIATOR SUPPORT SEAL
4. REMOVE V-BANK COVER SUB-ASSEMBLY
5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected
.
-
w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
6. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
7. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
8. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
9. REMOVE FAN AND GENERATOR V BELT
10. REMOVE FRONT FENDER APRON SEAL FRONT RH
11. REMOVE AIR CLEANER HOSE ASSEMBLY
12. REMOVE AIR CLEANER ASSEMBLY
13. DISCONNECT VANE PUMP ASSEMBLY
14. DISCONNECT OIL COOLER PIPE ASSEMBLY
15. REMOVE GENERATOR ASSEMBLY
|
(a) Disconnect the generator connector. |
(b) Remove the terminal cap and nut, and disconnect the generator wire.
(c) Remove the bolt and wire harness bracket from the generator.
|
(d) Remove the 3 bolts, nut and generator. |
|
|