Suzuki Vitara (LY) 2016-2017 · Service Manual Diagnostic Information and Procedures

Fail-Safe Table

Precautions: Precautions for Diagnosing Trouble · Precautions for Steering · General safety (00)

When any of the following DTCs is detected, P/S control module enters fail-safe mode as long as malfunction continues to exist but that mode is cancelled when the following cancel conditions are met after that.
DTC Fail-safe operation Fail-safe operation cancel condition
C1111 icon  P/S motor and fail-safe relay turned off. Ignition is set to “OFF”.
C1113 icon 
C1115 icon 
C1116 icon 
C1131 icon 
C1141 icon 
C1142 icon 
C1143 icon 
C1145 icon 
C1146 icon 
C1152 icon 
C1153 icon  P/S motor turned off or assist value is decreased to minimum. If one of the following conditions is met:
•Voltage at fail-safe relay contact is higher than 10 V or lower than 18.2 V.
•Ignition is set to “OFF”.
C1154 icon  P/S motor turned off. Recovery from malfunction or setting ignition to “OFF”.
C1155 icon  P/S motor turned off or P/S motor and fail-safe relay turned off. Recovery from malfunction or ignition is set to “OFF”.
C1160 icon  Default assist map is applied. Setting of correct assist map.
C1161 icon  Assist value is decreased to minimum. Normal data is received or ignition is set to “OFF”.
C1162 icon  Assist is stopped.
C1164 icon  Vehicle dynamics synthetic control is stopped.
C1166 icon  Assist value is decreased to minimum.
U0100 icon  Assist is stopped or assist value is decreased to minimum.