DTC B1167
Precautions: Precautions for Diagnosing Trouble · General safety (00)
DTC Detecting Condition and Trouble Area
| DTC detecting condition | Trouble area |
|---|---|
|
B1167: Immobilizer Information Mismatched Verification error between keyless start control module and ECM. |
•ECM ID code is not registered in keyless start control module
•Remote controller is not registered •ECM •Keyless start control module |
DTC Troubleshooting
NOTE:
If keyless start control module is used in another vehicle before, remote controller cannot be registered. Always install new keyless start control module whenever replacement is necessary.
| Step | Action | Yes | No |
|---|---|---|---|
| 1 |
DTC check
1)Set ignition “OFF” and leave ignition “OFF” for 5 seconds or more.
2)Set ignition “ON”
3)Recheck DTC.
Is current DTC B1167 detected?
|
Go to Step 2.
|
Check for intermittent trouble.
|
| 2 |
DTC check
1)Check DTC in ECM.
•M16A model:
•K14C model: •D16AA model: Is there any DTC detected?
|
Go to troubleshooting for applicable DTC.
|
Go to Step 3.
|
| 3 |
DTC recheck
1)Perform ECM Registration:Keyless Push Start Model.
2)Check that ignition is “OFF”.
3)Set ignition “ON”.
4)Recheck DTC.
Is DTC B1167 still detected?
|
Go to Step 4.
|
End. (ECM was not registered)
|
| 4 |
Remote controller registration
1)Perform “Immobilizer Key Registration”.
2)Check that ignition is “OFF”.
3)Set ignition “ON”.
4)Recheck DTC.
Is DTC B1167 still detected?
|
Replace keyless start control module and recheck DTC. If DTC B1167 is still detected, replace ECM and recheck DTC.
•Keyless start control module:
•ECM:
—M16A model:
—K14C model: —D16AA model: |
End. (Remote controller was not registered)
|