Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


  1. Before inspecting the suspected areas listed in the table below, check the fuse and relay.
  2. Before inspecting the suspected areas listed in the table below, check for DTCs.
  3. Methods used to verify the cause of the problem are listed in order of probability in the suspected area column.

Audio Function: 
Symptom
Suspected area
See page
Pressing power switch does not turn on system.
1. Proceed to "Pressing Power Switch does not Turn on System"
Click here
2. Radio receiver power source circuit
Click here
3. AVC-LAN circuit
Click here
4. Radio receiver
Click here
Panel switch does not function.
1. Steering pad switch circuit
Click here
2. AVC-LAN circuit
Click here
3. Radio receiver
Click here
No sound be heard from speakers. (Audio is mute.) (10 speaker system)
1. Radio receiver power source circuit
Click here
2. Proceed to "No Sound can be Heard from Speakers"
Click here
3. Stereo component amplifier power source circuit
Click here
4. Proceed to "Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier"
Click here
5. Speaker circuit
Click here
6. Proceed to "Mute Signal Circuit between Radio Receiver and Stereo Component Amplifier"
Click here
7. Proceed to "Mute Signal Circuit between Radio Receiver and Television Display Assembly" (*1)
Click here
8. Woofer box speaker assembly (Built-in stereo component amplifier)
Click here
9. Radio receiver
Click here
No sound be heard from speakers. (Audio is mute.) (6 speaker system)
1. Radio receiver power source circuit
Click here
2. Proceed to "No Sound can be Heard from Speakers"
Click here
3. Speaker circuit
Click here
4. Proceed to "Mute Signal Circuit between Radio Receiver and Television Display Assembly" (*1)
Click here
5. Radio receiver
Click here
Sound quality is bad in all modes. (Volume is too low.) (10 speaker system)
1. Proceed to "Poor Sound Quality in All Modes (Low Volume)"
Click here
2. Speaker circuit.
Click here
3. Proceed to "Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier"
Click here
4. Proceed to "Mute Signal Circuit between Radio Receiver and Stereo Component Amplifier"
Click here
5. Proceed to "Mute Signal Circuit between Radio Receiver and Television Display Assembly" (*1)
Click here
6. Woofer box speaker assembly (Built-in stereo component amplifier)
Click here
7. Radio receiver
Click here
Sound quality is bad in all modes. (Volume is too low.) (6 speaker system)
1. Proceed to "Poor Sound Quality in All Modes (Low Volume)"
Click here
2. Speaker circuit
Click here
3. Proceed to "Mute Signal Circuit between Radio Receiver and Television Display Assembly" (*1)
Click here
4. Radio receiver
Click here
ASL does not function. (10 speaker system)
Proceed to "Vehicle Speed Signal Circuit between Stereo Component Amplifier and Combination Meter"
Click here
ASL does not function. (6 speaker system)
Proceed to "Vehicle Speed Signal Circuit between Radio Receiver and Combination Meter"
Click here
RSE sound cannot be heard or sound quality is bad. (*1)
1. Radio receiver power source circuit
Click here
2. Television display assembly power source circuit
Click here
3. Proceed to "Sound Signal Circuit between Radio Receiver and Television Display Assembly"
Click here
4. Proceed to "Mute Signal Circuit between Radio Receiver and Television Display Assembly"
Click here
5. Radio receiver
Click here
6. Television display assembly
Click here
External device sound cannot be heard or sound quality is bad. (Stereo jack is used.)
1. Radio receiver power source circuit
Click here
2. Proceed to "Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter"
Click here
3. Stereo jack adapter
Click here
4. Radio receiver
Click here
Abnormal noise occurs. (10 speaker system)
1. Proceed to "Noise occurs"
Click here
2. Woofer box speaker assembly (Built-in stereo component amplifier)
Click here
3. Radio receiver
Click here
Abnormal noise occurs. (6 speaker system)
1. Proceed to "Noise occurs"
Click here
2. Radio receiver
Click here
Radio broadcast cannot be received or poor reception.
Proceed to "Radio Broadcast cannot be Received or Poor Reception"
Click here
CD cannot be inserted/played or CD is ejected right after insertion.
1. Radio receiver power source circuit
Click here
2. Proceed to "CD cannot be Inserted/Played or CD is Ejected Right After Insertion"
Click here
CD cannot be ejected.
1. Radio receiver power source circuit
Click here
2. Proceed to "CD cannot be Ejected"
Click here
Sound quality is bad only when CD is played. (Volume is too low.)
Proceed to "Sound Quality is Bad Only when CD is Played (Volume is Too Low)"
Click here
CD sound skips.
Proceed to "CD Sound Skips"
Click here
Radio receiver cannot be illuminated at night.
1. Illumination circuit
Click here
2. Radio receiver
Click here
*1: with Rear Seat Entertainment System

Steering Pad Switch Function: 
Symptom
Suspected area
See page
Audio system cannot be operated with steering pad switch.
1. Steering pad switch circuit
Click here
2. Radio receiver
Click here
Steering pad switch cannot be illuminated at night.
1. Illumination circuit
Click here
2. Radio receiver
Click here