Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here



COMMUNICATION STOP MODE TABLE
  1. Complete "CHECK CAN BUS LINE" to confirm that there is no malfunction in the CAN bus line. Select "BUS CHECK" on the intelligent tester via the CAN VIM.

  2. Check the communication stop mode of the ECUs or sensors not displayed among the following: "ENGINE", "ABS/VSC/TRAC", "YAW/DECELERAT" or "STEERING SENSOR".

    NOTICE:
    If 2 or more ECUs or sensors are not displayed on the intelligent tester via the CAN VIM, perform troubleshooting for the communication stop mode of each undisplayed ECU or sensor (Either side of the CAN sub bus lines may be open).


RESULT LIST OF HOW TO PROCEED WITH TROUBLESHOOTING 
Symptom
Suspected area
See page
The result of HOW TO PROCEED WITH TROUBLESHOOTING is Open in CAN Main Bus Line
CHECK CAN MAIN BUS LINE FOR DISCONNECTION
Click here
The result of HOW TO PROCEED WITH TROUBLESHOOTING is in CAN Bus Line
CHECK CAN BUS LINE
Click here
The result of HOW TO PROCEED WITH TROUBLESHOOTING is Short to +B in CAN Bus Line
CHECK CAN BUS LINE FOR SHORT TO +B
Click here
The result of HOW TO PROCEED WITH TROUBLESHOOTING is Short to GND in CAN Bus Line
CHECK CAN BUS LINE FOR SHORT TO GND
Click here
The result of HOW TO PROCEED WITH TROUBLESHOOTING is Short in CAN Bus Line
CHECK CAN SUB LINES FOR SHORT CIRCUIT
Click here

COMMUNICATION STOP MODE TABLE 
Symptom
Suspected area
See page
Skid control ECU is not displayed on the intelligent tester
SKID CONTROL ECU COMMUNICATION STOP MODE
Click here
Yaw rate sensor is not displayed on the intelligent tester
YAW RATE SENSOR COMMUNICATION STOP MODE
Click here
Steering sensor is not displayed on the intelligent tester
STEERING SENSOR COMMUNICATION STOP MODE
Click here