Home › Engine / Hybrid System › 1GR-FE LUBRICATION › ENGINE OIL COOLER › from 2013.08
RM1440E _51 Engine / Hybrid System _056130 1GR-FE LUBRICATION _0273917 ENGINE OIL COOLER A

1GR-FE LUBRICATION  ENGINE OIL COOLER  REMOVAL  


PROCEDURE

Hide 53298 1.REMOVE COOL AIR INTAKE DUCT (for 4WD with TOYOTA Parking Assist-sensor System)

Hide 52129B 2.REMOVE FRONT BUMPER LOWER COVER (w/o TOYOTA Parking Assist-sensor System)

Hide 52129B 3.REMOVE FRONT BUMPER LOWER COVER (w/ TOYOTA Parking Assist-sensor System)

Hide 52822 4.REMOVE AIR INTAKE DUCT LH (w/ TOYOTA Parking Assist-sensor System)

Hide 52821 5.REMOVE AIR INTAKE DUCT RH (w/ TOYOTA Parking Assist-sensor System)

Hide 51405A 6.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 16206 11.DISCONNECT WATER BY-PASS PIPE SUB-ASSEMBLY

a.
A225377

Remove the 3 bolts.


b.
A222108

Slide the 2 hose clamps and disconnect the 2 water by-pass hoses from the water by-pass pipe sub-assembly.


Hide 15710 13.REMOVE OIL COOLER ASSEMBLY

a.
A222109

Slide the 2 hose clamps and remove the 2 water by-pass hoses.


b.
A222110

Remove the oil cooler union bolt, nut and oil cooler assembly.


c.

Remove the seal washer from the oil cooler union bolt.