Refer to DTC C1419 and C1435 (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>C1419).
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1436 | Either condition is met:
1.
With the vehicle stationary, the yaw rate and acceleration sensor output value is not 0°/s. 2.
An abnormal comparison value. |
Yaw rate and acceleration sensor |
Refer to DTCs C1232, C1243, C1245 and C1381 (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>C1232).
When replacing the yaw rate and acceleration sensor, perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).
Check the yaw rate and acceleration sensor signal after replacement (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>TEST MODE PROCEDURE).
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
When DTC U0123, U0124 and/or U0126 is output together with DTC C1436, inspect and repair the trouble areas indicated by DTC U0123, U0124 and/or U0126 first (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>U0073).
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Yaw Rate Sensor | Yaw rate and acceleration sensor 1 reading/ Min.: -128°/s, Max.: 127°/s | Vehicle stationary: 0°/s
Right turn: -128 to 0°/s Left turn: 0 to 127°/s |
- |
Check that the yaw rate and acceleration sensor output value is displayed on the intelligent tester.
| Result | Proceed to | |
|---|---|---|
| NG | Yaw rate and acceleration sensor output value is 0°/s when vehicle is stationary, but value fluctuates when turning | A |
| Yaw rate and acceleration sensor output value is not 0°/s when vehicle is stationary | B | |
| OK | C | |
A
B
C
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
Turn the ignition switch off.
Check that the yaw rate and acceleration sensor is installed properly (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>YAW RATE AND ACCELERATION SENSOR>REMOVAL).
The sensor is tightened to the specified torque.
The sensor is not installed at an angle.
OK
NG
(See pageBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>YAW RATE AND ACCELERATION SENSOR>INSTALLATION)