Refer to DTCs C1421, C1423, C1424, C1455, C1457 and C1458 (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>C1281).
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1422 | When the stop light switch is off, the PM/C1 terminal voltage is 0.86 V or higher for 5 seconds or more. | ·
Stop light switch ·
Stop light switch circuit ·
Master cylinder pressure sensor circuit ·
Master cylinder solenoid (Master cylinder pressure sensor) |
| C1456 | When the stop light switch is off, the PCTRL terminal voltage is 0.86 V or higher for 5 seconds or more. | ·
Stop light switch ·
Stop light switch circuit ·
Pressure control sensor circuit ·
Master cylinder solenoid (Pressure control sensor) |
Refer to DTC C1380 (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>C1380).
When replacing the master cylinder solenoid, perform calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).
When DTC C1425 is output together with DTC C1422 and/or C1456, inspect and repair the trouble areas indicated by DTC C1425 first (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>C1425).
Check that the stop lights come on when the brake pedal is depressed and go off when the brake pedal is released.
| Condition | Illumination Condition |
|---|---|
| Brake pedal depressed | On |
| Brake pedal released | Off |
OK
NG
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Stop Light SW | Stop light switch/ ON or OFF | ON: Brake pedal depressed
OFF: Brake pedal released |
- |
Check that the stop light condition observed on the intelligent tester changes according to brake pedal operation.
The intelligent tester displays ON or OFF according to brake pedal operation.
OK
NG
Turn the ignition switch off.
Check the brake pedal height and stop light switch installation (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL>ADJUSTMENT).
The brake pedal height and stop light switch installation are normal.
OK
NG
Clear the DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).
Start the engine.
Drive the vehicle at a speed of 40 km/h (25 mph) or more and perform a braking test (decelerate the vehicle by depressing the brake pedal).
Check if the same DTC is output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC C1422 is not output | A |
| DTC C1422 is output | B |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
OK
NG