55106
1.INSTALL BRAKE PEDAL SUPPORT SUB-ASSEMBLY
Temporarily install the set bolt.
Install the hydraulic brake booster (See page Brake>BRAKE SYSTEM (OTHER)>HYDRAULIC BRAKE BOOSTER>INSTALLATION).
Install the brake pedal support sub-assembly with the 4 nuts.
Tighten the brake pedal support reinforcement set bolt.
47264A
2.INSTALL PUSH ROD PIN
Apply a light coat of lithium soap base glycol grease to the inner surface of the hole in the brake pedal lever.
| *1 | Lithium soap base glycol grease |
Set the master cylinder push rod clevis in place, insert the push rod pin from the left side of the vehicle, and then install a new clip.
47101A
3.INSTALL BRAKE PEDAL RETURN SPRING
Apply a light coat of lithium soap base glycol grease to inner surface of the hole in the brake pedal support sub-assembly.
Install the brake pedal return spring to the brake pedal support sub-assembly.
84340
4.INSTALL STOP LIGHT SWITCH ASSEMBLY
Install the stop light switch (See page Vehicle Exterior>LIGHTING (EXT)>STOP LIGHT SWITCH>INSTALLATION).
Connect the stop light switch connector.
55045
5.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
Install the lower instrument panel finish panel sub-assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>INSTALLATION).
6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
7.BLEED BRAKE SYSTEM
8.CHECK AND ADJUST BRAKE PEDAL
Check and adjust brake pedal (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL>ADJUSTMENT).