Home › Brake › BRAKE SYSTEM (OTHER) › HYDRAULIC BRAKE BOOSTER
RM1440E _54 Brake _056143 BRAKE SYSTEM (OTHER) _0274008 HYDRAULIC BRAKE BOOSTER A

BRAKE SYSTEM (OTHER)  HYDRAULIC BRAKE BOOSTER  INSTALLATION  


PROCEDURE

Hide 44785 1.INSTALL BRAKE BOOSTER GASKET

a.

Install a new brake booster gasket to the hydraulic brake booster.


Hide 2.INSTALL HYDRAULIC BRAKE BOOSTER ASSEMBLY

a.

Install the hydraulic brake booster assembly with the 4 nuts.

Torque:
14 N*m (145 kgf*cm, 10 ft.*lbf)


b.
C361956E01
0.719,0.76 1.177,0.76 1.177,0.76 1.177,1.198 false 1.281,0.146 1.573,0.146 1.573,0.146 1.573,1.531 true 2.448,0.24 2.313,0.24 2.313,0.24 2.021,1.74 true 2.854,0.771 2.677,0.771 2.677,0.771 2.479,1.823 true 0.469,0.667 0.708,0.854 0.24,0.188 10 false *3 1.073,0.073 1.313,0.26 0.24,0.188 10 false *1 2.5,0.167 2.74,0.354 0.24,0.188 10 false *2 2.927,0.698 3.167,0.885 0.24,0.188 10 false *4

Connect the 4 brake lines to the correct positions of the hydraulic brake booster assembly as shown in the illustration.

HINT:
·

*1: To front wheel cylinder RH

·

*2: To front wheel cylinder LH

·

*3: To rear wheel cylinder RH

·

*4: To rear wheel cylinder LH




c.

Using a union nut wrench, connect the 4 brake lines to the hydraulic brake booster assembly.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



d.
C361957

Connect the 3 connectors to the hydraulic brake booster.


Hide 55045 4.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

a.

Install the lower instrument panel finish panel sub-assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>INSTALLATION).


Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 7.CHECK AND ADJUST BRAKE PEDAL

a.

Check and adjust brake pedal (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL>ADJUSTMENT).


Hide 47217 8.INSPECT BRAKE MASTER CYLINDER OPERATION

a.

Inspect the brake master cylinder operation (See page Brake>BRAKE SYSTEM (OTHER)>HYDRAULIC BRAKE BOOSTER>ON-VEHICLE INSPECTION).


Hide 89180 9.PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION

a.

Perform yaw rate and acceleration sensor zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).