Home › Brake › PARKING BRAKE › PARKING BRAKE PEDAL
RM1440E _54 Brake _056146 PARKING BRAKE _0274014 PARKING BRAKE PEDAL A

PARKING BRAKE  PARKING BRAKE PEDAL  INSTALLATION  


PROCEDURE

Hide 46252 1.INSTALL PARKING PEDAL PAD

a.

Install the parking pedal pad.


Hide 46410 2.INSTALL NO. 1 PARKING BRAKE CABLE ASSEMBLY

a.

Connect the No. 1 parking brake cable No. 3 clamp to the No. 1 parking brake cable.


b.

Temporarily install the No. 1 parking brake cable assembly with the adjusting nut and lock nut.


c.

Install the No. 1 parking brake cable assembly with the 4 nuts and 3 bolts.

C215294E04
2.865,1.188 2.99,1.323 0.125,0.135 0.365,0.938 0.49,1.115 0.125,0.177 10 false A 0.354,0.406 0.479,0.583 0.125,0.177 10 true A 0.313,1.688 0.438,1.865 0.125,0.177 10 false A 0.323,2.25 0.448,2.427 0.125,0.177 10 false A 2.635,2.156 2.75,2.313 0.115,0.156 10 false B 3.885,1.958 4.042,2.146 0.156,0.188 10 true B 4.656,1.198 4.802,1.406 0.146,0.208 10 true B

Torque:
for nut A : 6.0 N*m (61 kgf*cm, 53 in.*lbf)
for bolt B : 13 N*m (127 kgf*cm, 9 ft.*lbf)


d.
C217118

Pass the No. 1 parking brake cable through the parking brake pedal.


e.

Install the clip.


f.

Bend the parking brake pedal claw.


g.

Temporarily install the adjusting nut and lock nut to the No. 1 parking brake cable.


Hide 46200 3.INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY

a.

Install the parking brake control pedal assembly with the 3 nuts.

Torque:
13 N*m (127 kgf*cm, 9 ft.*lbf)


b.

Connect the parking brake switch connector.


Hide 33550 4.INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY

Transmission Type See procedure
A750F (Click here)
A750E (Click here)

Hide 58910C 8.INSTALL REAR CONSOLE BOX ASSEMBLY

a.

Install the rear console box assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX>INSTALLATION).


Hide 55045 9.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

a.

Install the lower instrument panel finish panel sub-assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>INSTALLATION).


Hide 10.ADJUST PARKING BRAKE SHOE CLEARANCE AND PARKING BRAKE PEDAL TRAVEL

Hide 11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).