1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
55474C
2.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
55475A
3.REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
55910R
4.REMOVE HEATER CONTROL ASSEMBLY
55424C
5.REMOVE RADIO TUNER FINISH PANEL (w/o Audio)
86140A
6.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKETS (w/ Audio)
83290D
7.REMOVE ACCESSORY METER ASSEMBLY
Remove the 2 screws.
Disconnect the connector to remove the accessory meter assembly as shown in the illustration.