Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM
RM1440E _59 Vehicle Exterior _056166 WINDOW / GLASS _0274161 POWER WINDOW CONTROL SYSTEM J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  Driver Side Power Window Auto Up / Down Function does not Operate with Power Window Master Switch  


DESCRIPTION

If the auto up/down function does not operate, the cause may be one or more of the following:

·

The ECU in the power window regulator motor determines that the power window regulator motor has not been initialized.

·

The master switch has a malfunction.

·

The Hall IC in the front power window regulator motor has a malfunction.


PROCEDURE

1.CHECK FOR DTC

b.

Check for DTCs (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is not output A
DTC B2311 is output B
DTC B2312 is output C
DTC B2313 is output D
LIN communication system DTCs are output E



A

2.CHECK MANUAL UP/DOWN FUNCTION

B

C

D

E

2.CHECK MANUAL UP/DOWN FUNCTION
a.

Check that the front power window moves when the manual up/down function of the multiplex network master switch is operated (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK).

OK:

Front power window moves.




OK

3.READ VALUE USING INTELLIGENT TESTER (MULTIPLEX NETWORK MASTER SWITCH)

NG

GO TO "Driver Side Power Window does not Operate with Power Window Master Switch"

3.READ VALUE USING INTELLIGENT TESTER (MULTIPLEX NETWORK MASTER SWITCH)
a.

Use the Data List to check if the multiplex network master switch is functioning properly (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>DATA LIST / ACTIVE TEST).

Master Switch
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
D Door P/W Auto SW Driver side power window auto up/down signal / ON or OFF ON: Driver side power window auto up/down switch on power window regulator master switch operated
OFF: Driver side power window switch on power window regulator master switch not operated
-

OK:

On tester screen, item changes between ON and OFF according to above chart.




OK

4.READ VALUE USING INTELLIGENT TESTER (FRONT DOOR WINDOW REGULATORASSEMBLY LH)

NG

REPLACE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY

4.READ VALUE USING INTELLIGENT TESTER (FRONT DOOR WINDOW REGULATORASSEMBLY LH)
a.

Use the Data List to check if the front power window regulator is functioning properly (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>DATA LIST / ACTIVE TEST).

Master Switch
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
D Door P/W Auto SW Driver side power window auto up/down signal / ON or OFF ON: Driver side power window auto up/down switch operated
OFF: Driver side power window switch not operated
-


OK:

On tester screen, item changes between ON and OFF according to above chart.



OK

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

NG

REPLACE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY