Home › Vehicle Exterior › WINDOW / GLASS › BACK DOOR POWER WINDOW MOTOR › from 2012.08
RM1440E _59 Vehicle Exterior _056166 WINDOW / GLASS _0274168 BACK DOOR POWER WINDOW MOTOR A

WINDOW / GLASS  BACK DOOR POWER WINDOW MOTOR  INSTALLATION  


PROCEDURE

Hide 85720E 1.INSTALL BACK DOOR POWER WINDOW REGULATOR MOTOR ASSEMBLY

a.
B240224E02
0.594,1.01 0.75,1.219 0.156,0.208 10 true 1 2.167,0.823 2.354,1.021 0.188,0.198 10 false 2 1.5,0.229 1.656,0.385 0.156,0.156 10 true 3

Using a T25 "TORX" socket wrench, install the back door power window regulator motor assembly with the 3 screws.

HINT:
·

Tighten the 3 screws in the order shown in the illustration.

·

A new back door power window regulator uses self-tapping screws to thread new installation holes when the self-tapping screws are installed.



Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)


Hide 69807 2.INSTALL BACK DOOR POWER WINDOW REGULATOR SUB-ASSEMBLY

Hide 68290A 3.INSTALL OUTER BACK DOOR GLASS WEATHERSTRIP ASSEMBLY

Hide 68131 4.INSTALL BACK DOOR GLASS

Hide 68275 5.INSTALL BACK DOOR GLASS RUN

Hide 67381A 6.INSTALL NO. 1 BACK WINDOW WIPER MOTOR BRACKET

Hide 85120R 7.INSTALL REAR WIPER MOTOR AND BRACKET ASSEMBLY

Hide 76085 9.INSTALL REAR SPOILER SUB-ASSEMBLY

Hide 76893 10.INSTALL REAR NO. 1 SPOILER COVER

Hide 75815 12.INSTALL BACK DOOR OUTSIDE MOULDING RH

HINT:

Use the same procedure described for the LH side.


Hide 67848 13.INSTALL BACK DOOR SERVICE HOLE COVER LH

Hide 67847 14.INSTALL BACK DOOR SERVICE HOLE COVER RH

Hide 67848C 15.INSTALL NO. 2 BACK DOOR SERVICE HOLE COVER

Hide 89222A 16.INSTALL MULTIPLEX NETWORK DOOR ECU

Hide 86160Y 17.INSTALL REAR NO. 2 SPEAKER ASSEMBLY

Hide 64780A 18.INSTALL BACK DOOR TRIM PANEL ASSEMBLY

Hide 74650A 19.INSTALL ASSIST STRAP ASSEMBLY

Hide 74629A 20.INSTALL ASSIST STRAP HOLE COVER

Hide 21.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).