SMART KEY SYSTEM (for Entry Function) > Driver Side Door Entry Lock and Unlock Functions do not Operate |

| 1.CHECK POWER DOOR LOCK OPERATION |
When the door control switch on the multiplex network master switch assembly is operated, check that the doors unlock and lock according to the switch operation (Click here).
|
| ||||
| OK | |
| 2.CHECK WAVE ENVIRONMENT |
Bring the electrical key transmitter approximately 0.3 m (0.984 ft.) from the door outside handle (for driver side) and perform a driver side door entry lock and unlock operation check (Click here).
|
| ||||
| OK | ||
| ||
| 3.READ VALUE USING TECHSTREAM (DOOR LOCK POSITION SWITCH) |
Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Main Body / Data List.
Read the Data List according to the display on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| FL Door Lock Pos | Front LH side door lock position switch signal / UNLOCK or LOCK | UNLOCK: Front LH side door unlocked LOCK: Front LH side door locked | - |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (FRONT DOOR OUTSIDE HANDLE - CERTIFICATION ECU) |
Disconnect the M1 handle connector.
Disconnect the F79 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| M1-3 (ANT2) - F79-4 (CG1B) | Always | Below 1 Ω |
| M1-6 (ANT1) - F79-3 (CLG1) | Always | Below 1 Ω |
| M1-5 (B) - F79-32 (POS1) | Always | Below 1 Ω |
| M1-2 (GND) - Body ground | Always | Below 1 Ω |
| F79-4 (CG1B) - Body ground | Always | 10 kΩ or higher |
| F79-3 (CLG1) - Body ground | Always | 10 kΩ or higher |
| F79-32 (POS1) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.CHECK CERTIFICATION ECU |
![]() |
Disconnect the M1 handle connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| M1-3 (ANT2) - M1-6 (ANT1) | Engine switch off, all doors closed, key not in cabin and transmitter lock switch not pressed → pressed | No pulse generation → Pulse generation |
| M1-5 (B) - Body ground | Engine switch off → on (IG) | 9 to 14 V → Below 2 V |
| *a | Front view of wire harness connector (to Front Door Outside Handle Assembly [for Driver Side]) |
|
| ||||
| OK | |
| 6.REPLACE FRONT DOOR OUTSIDE HANDLE ASSEMBLY (FOR DRIVER SIDE) |
Temporarily replace the front door outside handle assembly (for driver side) with a new or normally functioning one (Click here).
| NEXT | |
| 7.CHECK FRONT DOOR OUTSIDE HANDLE ASSEMBLY (OPERATION) |
Check that the entry functions operate normally (Click here).
|
| ||||
| OK | ||
| ||