POWER WINDOW CONTROL SYSTEM > Driver Side Power Window Auto Up / Down Function does not Operate with Power Window Master Switch |
| 1.CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC B2311 is output | B |
| DTC B2312 is output | C |
| DTC B2313 is output | D |
| LIN communication system DTCs are output | E |
|
| ||||
|
| ||||
|
| ||||
|
| ||||
| A | |
| 2.CHECK MANUAL UP/DOWN FUNCTION |
Check that the front power window moves when the manual up/down function of the multiplex network master switch is operated (Click here).
|
| ||||
| OK | |
| 3.READ VALUE USING TECHSTREAM (MULTIPLEX NETWORK MASTER SWITCH) |
Use the Data List to check if the multiplex network master switch is functioning properly (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| D Door P/W Auto SW | Driver side power window auto up/down signal / ON or OFF | ON: Driver side power window auto up/down switch on power window regulator master switch operated OFF: Driver side power window switch on power window regulator master switch not operated | - |
|
| ||||
| OK | |
| 4.READ VALUE USING TECHSTREAM (FRONT DOOR WINDOW REGULATOR ASSEMBLY LH) |
Use the Data List to check if the front power window regulator is functioning properly (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| D Door P/W Auto SW | Driver side power window auto up/down signal / ON or OFF | ON: Driver side power window auto up/down switch operated OFF: Driver side power window switch not operated | - |
|
| ||||
| OK | ||
| ||