19100P
1.INSTALL SPARK PLUG (for Bank 1)
Install the 2 spark plugs onto the cylinder head sub-assembly.
If a component has been dropped or subjected a strong impact, replace it.
19500
2.INSTALL IGNITION COIL ASSEMBLY (for Bank 1)
Install the 2 ignition coils onto the cylinder head cover sub-assembly with the 2 bolts.
If a component has been dropped or subjected a strong impact, replace it.
Connect the 2 ignition coil connectors to the ignition coil.
If a spring is used on the connector, make sure that the spring is back in the original position as shown in the illustration.
| *a | Spring |
89871
3.INSTALL INJECTOR DRIVER
19100P
4.INSTALL SPARK PLUG (for Bank 2)
Install the 2 spark plugs onto the cylinder head sub-assembly.
If a component has been dropped or subjected a strong impact, replace it.
19500
5.INSTALL IGNITION COIL ASSEMBLY (for Bank 2)
Install the 2 ignition coils onto the cylinder head cover sub-assembly with the 2 bolts.
If a component has been dropped or subjected a strong impact, replace it.
Connect the 2 ignition coil connectors to the ignition coil.
If a spring is used on the connector, make sure that the spring is back in the original position as shown in the illustration.
| *a | Spring |
23261A
6.INSTALL INJECTOR COVER (for Bank 2)
Install the injector cover with the 2 bolts.
Engage the clamp, and install the fuel hoses.
7.REMOVE SST
Hoist the engine assembly up with an engine sling device and a mini crane.
Remove the SST.
Install the 2 nuts.
Remove the rope that is tying the front exhaust pipe sub-assembly to the front suspension cross member sub-assembly.
8.REMOVE ENGINE HANGER
17141
9.INSTALL EXHAUST MANIFOLD
31484A
10.INSTALL CLUTCH FLEXIBLE HOSE BRACKET (for RHD with Manual Transmission)
Install the clutch flexible hose bracket with the bolt.
Connect the clutch flexible tube with the clip.
82121
11.CONNECT ENGINE WIRE
Connect the engine wire with the wire harness clamp bracket mount bolt and 3 clamps.
Connect the engine wire with the 4 clamps.
12.INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE
53608
13.INSTALL FRONT SUSPENSION UPPER TO COWL BRACE SUB-ASSEMBLY LH
53607
14.INSTALL FRONT SUSPENSION UPPER TO COWL BRACE SUB-ASSEMBLY RH
15.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL