1.CHECK FUEL PUMP OPERATION AND INSPECT FOR FUEL LEAK
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
3.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE
22030
4.REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY
Remove the 4 bolts and and disconnect the throttle with motor body assembly.
Remove the gasket.
89871
5.REMOVE INJECTOR DRIVER
23261A
6.REMOVE INJECTOR COVER (for Bank 2)
23261A
7.REMOVE INJECTOR COVER (for Bank 1)
8.DISCONNECT NO. 1 FUEL HOSE (for Clamp Type)
77259D
9.DISCONNECT NO. 1 FUEL HOSE (for Metal Type)
23807
10.DISCONNECT FUEL DELIVERY PIPE SUB-ASSEMBLY
Remove the bolt and disconnect the fuel delivery pipe sub-assembly.
Disconnect the No. 2 fuel vapor feed hose and move the fuel delivery pipe toward the front of the vehicle.
12601B
11.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY (w/ Air Conditioning System)
Disengage the 3 craws and remove the No. 1 engine cover sub-assembly.
Disengage the 3 craws in the order shown in the illustration.
44771
12.DISCONNECT VACUUM TUBE CONNECTOR HOSE (for Manual Transmission)
12261
13.DISCONNECT VENTILATION HOSE
Disconnect the ventilation hose.
17111
14.REMOVE INTAKE MANIFOLD
Disconnect the manifold absolute pressure sensor connector.
Disconnect the purge valve connector.
Disengage the 5 clamps and disconnect the battery cable.
Disengage the clamp and disconnect the engine wire harness.
Disengage the 2 clamps and disconnect the 4 connectors.
| *a | for Bank 2 |
| *b | for Bank 1 |
Disconnect the fuel pump connector.
Remove the 6 bolts, intake manifold and 2 gaskets.
| *a | for Bank 2 |
| *b | for Bank 1 |