The cruise control main switch is used to turn the cruise control system on and off, as well as operate 7 functions: SET, - (COAST), TAP-DOWN, RES (RESUME), + (ACCEL), TAP-UP and CANCEL. The SET, TAP-DOWN and - (COAST) functions, and the RES (RESUME), TAP-UP and + (ACCEL) functions are operated with the same switch. The cruise control main switch is an automatic return type switch which turns on only while operating it in the direction of each arrow and turns off after releasing it. The internal contact points of the cruise control main switch turn on with switch operation. Then the ECM reads the voltage value that has been changed by the switch operation to control SET, - (COAST), RES (RESUME), + (ACCEL), and CANCEL.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Select the following menu items: Powertrain / Cruise Control / Data List.
Check the Data List to confirm proper functioning of the cruise control main switch.
| *a | ON-OFF |
| *b | -/SET |
| *c | +/RES |
| *d | CANCEL |
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Main SW M-CPU | Cruise control main switch signal (Main CPU) / ON or OFF | ON: cruise control main switch (ON-OFF button) pushed
OFF: cruise control main switch (ON-OFF button) released |
- |
| Cancel Switch | CANCEL switch signal / ON or OFF | ON: CANCEL switch on
OFF: CANCEL switch off |
- |
| SET/COAST Switch | -/SET switch signal / ON or OFF | ON: -/SET switch on
OFF: -/SET switch off |
- |
| RES/ACC Switch | +/RES switch signal / ON or OFF | ON: +/RES switch on
OFF: +/RES switch off |
- |
When the cruise control main switch is operated, the display changes as shown above.
OK
NG
Inspect the cruise control main switch assembly (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL MAIN SWITCH>INSPECTION).
OK
NG
Disconnect the cruise control main switch assembly connector.
Disconnect the spiral cable with sensor sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
|---|---|
| Cruise control main switch side connector terminal 3 (R) - z8-11 | Below 1 Ω |
| Cruise control main switch side connector terminal 1 (B) - z8-10 | Below 1 Ω |
| *a | Front view of wire harness connector
(to Spiral Cable with Sensor Sub-assembly) |
| *b | Front view of wire harness connector
(to Cruise Control Main Switch Assembly) |
OK
NG
Inspect the spiral cable with sensor sub-assembly (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>INSPECTION).
OK
NG
Disconnect the ECM connector.
Disconnect the spiral cable with sensor sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A33-30 (CCS) - D77-6 (CCS) | Always | Below 1 Ω |
| A33-4 (EC) - D77-5 (ECC) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A33-30 (CCS) or D77-6 (CCS) - Body ground | Always | 10 kΩ or higher |
| A33-4 (EC) or D77-5 (ECC) - Body ground | Always | 10 kΩ or higher |
OK
NG