45111
1.REMOVE STEERING WHEEL ASSEMBLY
2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
3.INSPECT SPIRAL CABLE SUB-ASSEMBLY
55318C
4.REMOVE INSTRUMENT SIDE PANEL (w/o Knee Airbag)
55606
5.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)
6.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)
55405B
7.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
55403
8.REMOVE METER HOOD SUB-ASSEMBLY
55422
9.REMOVE UPPER INSTRUMENT PANEL METER ORNAMENT
45289A
10.REMOVE STEERING COLUMN COVER SUPPORT (w/ Entry and Start System)
11.REMOVE LOWER STEERING COLUMN COVER
45286
12.REMOVE UPPER STEERING COLUMN COVER
13.REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
89245B
14.REMOVE STEERING SENSOR
Remove the steering sensor from the spiral cable sub-assembly only when replacing it or the steering sensor.
Do not rotate the center section of the steering sensor, as it may deviate from the steering sensor neutral point.
When replacing the spiral cable sub-assembly: (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>REMOVAL)
Disengage the 6 claws, 2 pins and 2 guides to remove the spiral cable sub-assembly from the steering sensor.
Do not damage the guide and claw.
| *1 | Guide |
| *2 | Pin |