Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM › from 2016.06
RM2090E _56 Audio / Visual / Telematics _060692 AUDIO / VIDEO _0297650 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Steering Pad Switch Circuit  


DESCRIPTION

This circuit sends an operation signal from the steering pad switch assembly to the radio receiver assembly.

If there is an open in this circuit, the audio system cannot be operated using the steering pad switch assembly.

If there is a short in this circuit, the same condition as when a switch is continuously depressed occurs.

Therefore, the radio receiver assembly cannot be operated using the steering pad switch assembly, and also the radio receiver assembly itself cannot function.

WIRING DIAGRAM

E351764E04
1.229,1.594 1.969,1.948 0.74,0.354 10 false Volume+ 0.479,1.594 1.219,1.948 0.74,0.354 10 false Volume- 2.656,1.083 3.396,1.438 0.74,0.354 10 false MODE 2.646,1.594 3.385,1.948 0.74,0.354 10 false Seek+ 1.958,1.594 2.698,1.948 0.74,0.354 10 false Seek- 1.802,2.344 2.542,2.698 0.74,0.354 10 false LH 4.073,1.833 4.813,2.188 0.74,0.354 10 false z9 4.073,1.292 4.813,1.646 0.74,0.354 10 false z9 4.073,0.813 4.813,1.167 0.74,0.354 10 false z9 4.104,1.625 4.844,1.979 0.74,0.354 10 false 6 4.104,1.104 4.844,1.458 0.74,0.354 10 false 5 4.063,0.615 4.802,0.969 0.74,0.354 10 false 12 4.99,0.823 5.729,1.177 0.74,0.354 10 false D77 4.979,1.313 5.719,1.667 0.74,0.354 10 false D77 4.365,1.208 5.104,1.563 0.74,0.354 10 false AU GND 4.49,0.708 5.229,1.063 0.74,0.354 10 false AU2 4.49,1.729 5.229,2.083 0.74,0.354 10 false AU1 4.979,1.844 5.719,2.198 0.74,0.354 10 false D77 5.063,0.604 5.802,0.958 0.74,0.354 10 false 9 5.021,1.094 5.76,1.448 0.74,0.354 10 false 13 5.021,1.625 5.76,1.979 0.74,0.354 10 false 14 5.76,0.813 6.5,1.167 0.74,0.354 10 false SW2+ 5.76,1.302 6.5,1.656 0.74,0.354 10 false SWGND 5.76,1.833 6.5,2.188 0.74,0.354 10 false SW1+ 5.479,0.719 6.219,1.073 0.74,0.354 10 false 22 5.479,1.208 6.219,1.563 0.74,0.354 10 false 23 5.479,1.729 6.219,2.083 0.74,0.354 10 false 21 5.823,2.688 6.563,3.042 0.74,0.354 10 false D12 0.813,2.771 3.26,3.271 2.448,0.5 10 false Steering Pad Switch Assembly 3.844,2.75 5.49,3.323 1.646,0.573 10 false Spiral Cable with Sensor Sub-assembly 5.823,2.865 6.917,3.354 1.094,0.49 10 false Radio Receiver Assembly

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (STEERING PAD SWITCH SIGNAL)
a.

Disconnect the D12 radio receiver assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
D12-21 (SW1+) - D12-23 (SWGND) No switch pushed 95 to 105 kΩ
Seek+ switch pushed Below 2.5 Ω
Seek- switch pushed 313 to 345 Ω
Volume+ switch pushed 950 to 1050 Ω
Volume- switch pushed 2955 to 3265 Ω
D12-22 (SW2+) - D12-23 (SWGND) No switch pushed 95 to 105 kΩ
MODE switch pushed Below 2.5 Ω




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.INSPECT STEERING PAD SWITCH ASSEMBLY
2.INSPECT STEERING PAD SWITCH ASSEMBLY
a.

Remove the steering pad switch assembly. (See Page Steering>STEERING COLUMN>STEERING PAD SWITCH>REMOVAL)


b.

Inspect the steering pad switch assembly. (See Page Steering>STEERING COLUMN>STEERING PAD SWITCH>INSPECTION)



OK

3.INSPECT SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

NG

REPLACE STEERING PAD SWITCH ASSEMBLY

3.INSPECT SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
a.

Remove the spiral cable with sensor sub-assembly. (See Page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>REMOVAL)


b.

Inspect the spiral cable with sensor sub-assembly. (See Page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>INSPECTION)



OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY)

NG

REPLACE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY