Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
43502C
1.INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH
Install the front axle hub sub-assembly to the steering knuckle with 4 new bolts.
Do not allow any foreign matter such as dirt or dust to enter between the steering knuckle and the front axle hub sub-assembly.
2.INSPECT FRONT AXLE HUB BEARING LOOSENESS
3.INSPECT FRONT AXLE HUB RUNOUT
89543
4.INSTALL FRONT SPEED SENSOR LH
Install the front speed sensor to the steering knuckle with the bolt.
Do not allow any foreign matter such as dirt or dust to enter between the steering knuckle and the front disc brake dust cover.
43512
5.INSTALL FRONT DISC
for floating type caliper:Brake>BRAKE (FRONT)>FRONT BRAKE (for Floating Type Caliper)>INSTALLATION
for opposed type caliper:Brake>BRAKE (FRONT)>FRONT BRAKE(for Opposed Type Caliper)>INSTALLATION
47710A
6.INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY
7.INSTALL FRONT WHEEL
8.INSPECT SPEED SENSOR SIGNAL