Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB › from 2017.03
RM2090E _52 Drivetrain _060678 AXLE AND DIFFERENTIAL _0297588 REAR AXLE HUB A

AXLE AND DIFFERENTIAL  REAR AXLE HUB  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 42450B 1.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH

a.

Install the rear axle hub and bearing assembly to the rear axle assembly with the 4 bolts.

Torque:
65 N*m (663 kgf*cm, 48 ft.*lbf)


Hide 47810A 3.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

Hide 42312B 4.INSTALL REAR AXLE SHAFT NUT LH

a.

Clean the threaded parts on the rear drive shaft assembly and a new rear axle shaft nut using a non-residue solvent.

NOTICE:
·

Be sure to perform this step even when using a new rear drive shaft assembly.

·

Keep the threaded parts free of oil and foreign matter.




b.

Install a new rear axle shaft nut.

Torque:
190 N*m (1937 kgf*cm, 140 ft.*lbf)

HINT:

Stake the rear axle shaft nut LH after inspecting for looseness and runout in the following steps.



Hide 42312B 7.STAKE REAR AXLE SHAFT NUT LH

a.
C259945

Using a chisel and hammer, stake the rear axle shaft nut LH.


Hide 89546 8.INSTALL REAR SPEED SENSOR LH

a.

Install the rear speed sensor LH with the bolt.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


Hide 9.INSTALL REAR WHEEL

Torque:
120 N*m (1224 kgf*cm, 89 ft.*lbf)

Hide 10.ADJUST PARKING BRAKE LEVER TRAVEL