1.INSPECT BRAKE LINE PIPES AND HOSES
Work in a well-lighted area. Turn the front wheels fully to the right or left before beginning the inspection.
Using a mirror, check the entire circumference and length of the brake lines and hoses for:
Damage
Wear
Deformation
Cracks
Corrosion
Leaks
Bends
Twists
Check all the clamps for tightness and the connections for leakage.
Check that the hoses and lines are not near sharp edges, moving parts or the exhaust system.
Check that the lines are installed properly and pass through the center of the grommets.
2.INSPECT BRAKE PEDAL
for LHD with 3SZ-VE Engine: See page Brake>BRAKE SYSTEM (OTHER)>3SZ-VE BRAKE PEDAL(for LHD)>ADJUSTMENT
for LHD with K3-VE Engine: See page Brake>BRAKE SYSTEM (OTHER)>K3-VE BRAKE PEDAL(for LHD)>ADJUSTMENT
for RHD: See page Brake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL(for RHD)>ADJUSTMENT
3.INSPECT PARKING BRAKE
4.INSPECT BRAKE LININGS AND DISCS
Check the brake linings and drums. Also check the brake linings of parking brake.
5.INSPECT FRONT BRAKE
Check the front brake pads and discs (See page Brake>BRAKE (FRONT)>FRONT BRAKE>INSPECTION).
6.INSPECT REAR BRAKE
Check the rear brake linings and drums (See page Brake>BRAKE (REAR)>REAR BRAKE>INSPECTION).
7.INSPECT OR CHARGE BRAKE FLUID
(See page Brake>BRAKE SYSTEM (OTHER)>BRAKE FLUID>ON-VEHICLE INSPECTION)
SAE J1703 or FMVSS No. 116 DOT3