Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR DIFFERENTIAL CARRIER OIL SEAL › 2011.11–2015.08
RM19Y0E _52 Drivetrain _002987 AXLE AND DIFFERENTIAL _0015123 REAR DIFFERENTIAL CARRIER OIL SEAL A

AXLE AND DIFFERENTIAL  REAR DIFFERENTIAL CARRIER OIL SEAL  REPLACEMENT  


PROCEDURE

Hide 1.DRAIN DIFFERENTIAL OIL

a.

Remove the rear axle housing filler plug, rear axle housing drain plug and 2 gaskets, and then drain the oil.


b.

Install the rear axle housing drain with a new gasket.

Torque:
61 N*m (625 kgf*cm, 45 ft.*lbf)

NOTICE:

Make sure that the oil temperature is low before servicing, as the oil may be hot after driving.



Hide 2.DRAIN MANUAL TRANSMISSION OIL (for Manual Transmission)

Hide 3.DRAIN AUTOMATIC TRANSMISSION FLUID (for Automatic Transmission)

Hide 37100 4.REMOVE PROPELLER SHAFT ASSEMBLY

Hide 5.REMOVE REAR DRIVE PINION NUT

a.
C267612N01
1.24,0.781 1.521,1.771 true 1.448,1.833 2.073,2.135 0.625,0.302 10 SST

Using SST and a hammer, unstake the nut.


b.
C267613C01
0.75,1.385 0.896,1.688 false 0.708,3.438 1,3.927 true 0.094,0.083 0.635,0.448 0.542,0.365 10 *A 0.146,2.479 0.688,2.844 0.542,0.365 10 *B 0.813,1.75 1.313,2.229 0.5,0.479 10 SST 0.906,4 1.406,4.479 0.5,0.479 10 SST
*A for Manual Transmission
*B for Automatic Transmission


Using SST, hold the flange and remove the nut.

i.

for Manual Transmission:

SST
09330-87301  


ii.

for Automatic Transmission:

SST
09330-00021  
09950-30012  (09955-03030)



Hide 41204 6.REMOVE REAR DRIVE PINION COMPANION FLANGE SUB-ASSEMBLY

a.
C267614N01
1.927,0.448 2.208,0.25 2.208,0.25 2.156,0.5 false 2.094,0.063 2.688,0.458 0.594,0.396 10 SST

Using SST, remove the companion flange.

SST
09950-30012  (09951-03010, 09953-03010, 09954-03010, 09955-03030, 09956-03020)

HINT:

For the AT model, a bolt (40 mm M 10 x 1.25) should be used to install SST (09955-03030) to the flange.



Hide 7.REMOVE REAR DIFFERENTIAL CARRIER OIL SEAL

a.
C267615N01
2.125,0.719 2.479,0.344 false 2.531,0.25 3.188,0.573 0.656,0.323 10 SST

Using SST, remove the rear differential carrier oil seal.

SST
09308-10010  


Hide 8.INSTALL REAR DIFFERENTIAL CARRIER OIL SEAL

a.
C267616N01
1.417,1.229 1.417,1.708 true 1.281,1.76 1.938,2.135 0.656,0.375 10 SST

Using SST and a hammer, install a new oil seal.

SST
09554-22010  

Oil seal drive in depth:

0 to 1.0 mm (0 to 0.039 in.)


NOTICE:

Evenly tap in the oil seal so that it is correctly installed.



b.

Apply MP grease to the oil seal lip.


Hide 9.INSTALL REAR DRIVE PINION COMPANION FLANGE SUB-ASSEMBLY

a.

install the companion flange to the differential carrier.


Hide 10.INSTALL REAR DRIVE PINION NUT (for Manual Transmission)

a.
C154558N01
1.073,1.26 1.229,1.479 false 1.146,1.521 1.677,1.917 0.531,0.396 10 SST

Install the washer.


b.

Using SST to hold the flange, tighten a new nut.

SST
09330-87301  

Torque:
157 N*m (1600 kgf*cm, 116 ft.*lbf)


c.
C145192C01
0.583,0.583 2.885,0.198 2.885,0.198 2.865,0.573 false 1.708,0.583 2.885,0.198 false 2.917,0.063 3.396,0.542 0.479,0.479 10 *1 0.49,1.667 1.021,2.042 0.531,0.375 10 *a 1.656,1.667 2.219,2.052 0.563,0.385 10 *b 2.813,1.667 3.177,1.979 0.365,0.313 10 *b
*1 Chisel
*a Right
*b Wrong


Using a chisel and a hammer, stake the nut.


Hide 11.INSTALL REAR DRIVE PINION NUT (for Automatic Transmission)

a.

Install the washer.


b.
C267617N01
0.948,1.208 1.292,1.667 true 1.198,1.75 1.844,2.125 0.646,0.375 10 SST

Using SST to hold the flange, tighten a new nut.

SST
09330-00021  
09950-30012  (09955-03030)

Torque:
157 N*m (1600 kgf*cm, 116 ft.*lbf)


c.
C145192C02
0.583,0.583 2.885,0.198 2.885,0.198 2.865,0.573 false 1.708,0.583 2.885,0.198 false 2.917,0.063 3.396,0.542 0.479,0.479 10 *1 0.49,1.667 1.021,2.042 0.531,0.375 10 *a 1.656,1.667 2.219,2.052 0.563,0.385 10 *b 2.813,1.667 3.177,1.979 0.365,0.313 10 *b
*1 Chisel
*a Right
*b Wrong


Using a chisel and a hammer, stake the nut.


Hide 37100 12.INSTALL PROPELLER SHAFT ASSEMBLY

Hide 13.ADD MANUAL TRANSMISSION OIL (for Manual Transmission)

Hide 14.INSPECT MANUAL TRANSMISSION OIL (for Manual Transmission)

Hide 15.ADD AUTOMATIC TRANSMISSION FLUID (for Automatic Transmission)

Hide 16.INSPECT AUTOMATIC TRANSMISSION FLUID LEVEL (for Automatic Transmission)

Hide 18.INSPECT FOR OIL LEAK