55106
1.INSTALL BRAKE PEDAL SUPPORT SUB-ASSEMBLY (for Automatic Transmission)
Temporarily install the brake mounting bracket with the bolt A.
Temporarily install bolt B.
Hook and hold the brake pedal support sub-assemblyonto the bolt B used for the temporary installation.
Install the brake pedal support sub-assembly with the bolt B and 4 nuts.
Tighten the bolt A.
55106
2.INSTALL BRAKE PEDAL SUPPORT SUB-ASSEMBLY (for Manual Transmission)
Temporarily install the brake mounting bracket with the bolt A.
Install the brake support sub-assembly as shown the illustration.
Install the 3 bolts.
Connect the connector to the clutch start switch assembly.
Tighten the bolt A.
47264D
3.CONNECT BRAKE MASTER CYLINDER PUSH ROD CLEVIS (for Automatic Transmission)
31340
4.CONNECT CLUTCH RELEASE CABLE ASSEMBLY (for Manual Transmission)
84345
5.INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER
Install the stop light switch mounting adjuster onto the pedal support sub-assembly.
84340
6.INSTALL STOP LIGHT SWITCH ASSEMBLY
| *1 | Adjuster |
| *2 | Cushion |
| *3 | Stop light switch assembly |
Insert the stop light switch assembly into the adjuster until it just touches the stop light switch cushion.
Do not depress the brake pedal.
| *1 | Shaft |
| *2 | Stop light switch assembly |
| *a | 0.2 to 2.8 mm
(0.008 to 0.110 in.) |
Turn the stop light switch assembly 90° clockwise to install it.
Do not depress the brake pedal.
Check the stop light switch assembly clearance.
0.2 to 2.8 mm (0.008 to 0.110 in.)
Connect the connector to the stop light switch assembly.
84520
7.INSTALL CLUTCH START SWITCH ASSEMBLY (for Manual Transmission)
31301
8.INSPECT AND ADJUST CLUTCH PEDAL SUB-ASSEMBLY
47101
9.INSPECT AND ADJUST BRAKE PEDAL SUB-ASSEMBLY
55545
10.INSTALL FUSE BOX OPENING COVER (for Manual Transmission)
44610
11.INSTALL BRAKE BOOSTER ASSEMBLY (for Manual Transmission)
45250
12.INSTALL STEERING COLUMN ASSEMBLY (for Manual Transmission)
45287
13.INSTALL LOWER STEERING COLUMN COVER (for Automatic Transmission)
83100
14.INSTALL COMBINATION METER ASSEMBLY