Use the same procedure for the RHD and LHD vehicles.
The procedure listed below is for the LHD vehicles.
1.REMOVE FRONT WHEEL
2.REMOVE FRONT BUMPER ASSEMBLY
75602A
3.REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY
4.REMOVE BODY ROCKER PANEL MOULDING ASSEMBLY
53876A
5.REMOVE FRONT FENDER LINER LH
Use the same procedure as for the RH side.
Click hereVehicle Exterior>WIPER / WASHER>WASHER MOTOR>REMOVAL
53117C
6.REMOVE NO. 1 RADIATOR GRILLE RETAINER
16561C
7.REMOVE NO. 1 RADIATOR TO SUPPORT SEAL
8.REMOVE HOOD LOCK NUT CAP
53510
9.REMOVE HOOD LOCK ASSEMBLY (w/ Engine Hood Courtesy Switch)
53510
10.REMOVE HOOD LOCK ASSEMBLY (w/o Engine Hood Courtesy Switch)
| *a | Hood Lock Bolt |
Remove the 2 bolts and hood lock bolt.
Disengage the guide to remove the hood lock assembly from the hood lock control cable assembly.
53601
11.DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
53632
12.REMOVE HOOD LOCK CONTROL CABLE HOLDER
|
Remove in this Direction |
Disengage the claw to remove the hood lock control cable holder as shown in the illustration.
53601
13.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Remove the hood lock control lever sub-assembly from the hood lock control cable assembly.
53630
14.REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)
Disconnect the hood lock control cable assembly from the clamps.
| *a | Grommet | - | - |
Disengage the grommet.
Pull the hood lock control cable assembly from the engine compartment to remove it.
53630
15.REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)
Disconnect the hood lock control cable assembly from the clamps.
| *a | Grommet | - | - |
Disengage the grommet.
Pull the hood lock control cable assembly from the engine compartment to remove it.