Home › Drivetrain › EC6A (MANUAL TRANSMISSION / TRANSAXLE) › BACK-UP LIGHT SWITCH › 2016.10–2019.09
RM32H0E _52 Drivetrain _059609 EC6A MANUAL TRANSMISSION / TRANSAXLE _0292323 BACK-UP LIGHT SWITCH A

EC6A MANUAL TRANSMISSION / TRANSAXLE  BACK-UP LIGHT SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the back-up light switch assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point
·

Lane departure alert system (w/ Steering Control)

·

Simple intelligent parking assist system*1

·

Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1

·

Pre-collision system


(Click here)
Initialize back door lock Power door lock control system (Click here)


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Click hereGeneral>MAINTENANCE>8NR-FTS BATTERY>REMOVAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 28800 3.REMOVE BATTERY

Hide 53141F 4.REMOVE RADIATOR COVER

Hide 17751 5.REMOVE NO. 1 AIR CLEANER INLET

Hide 17705 6.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

Hide 17701 7.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Hide 84210 10.REMOVE BACK-UP LIGHT SWITCH ASSEMBLY

a.
C365832

Disconnect the back-up light switch assembly connector.


b.
C365833C01
0.885,0.583 1.115,0.365 true 1.135,0.292 1.344,0.469 0.208,0.177 10 true *a
*a 27 mm Deep Socket Wrench


Using a 27 mm deep socket wrench, remove the back-up light switch assembly and gasket from the manual transaxle assembly.