Home › Drivetrain › K114 (MULTIDRIVE / CVT) › REVOLUTION SENSOR › 2016.10–2020.08
RM32H0E _52 Drivetrain _059616 K114 MULTIDRIVE / CVT _0292455 REVOLUTION SENSOR A

K114 MULTIDRIVE / CVT  REVOLUTION SENSOR  INSTALLATION  


PROCEDURE

Hide 89413N 1.INSTALL TRANSMISSION REVOLUTION SENSOR (NT)

a.

Apply Toyota Genuine CVT fluid FE to a new O-ring.


b.

Install the O-ring to the transmission revolution sensor (NT).


c.

Install the transmission revolution sensor (NT) to the continuously variable transaxle assembly with the bolt.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


d.

Connect the connector.


Hide 89413M 2.INSTALL TRANSMISSION REVOLUTION SENSOR (NOUT)

a.

Apply Toyota Genuine CVT fluid FE to a new O-ring.


b.

Install the O-ring to the transmission revolution sensor (NOUT).


c.

Install the transmission revolution sensor (NOUT) to the continuously variable transaxle assembly with the bolt.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


d.

Connect the connector.


Hide 89413P 3.INSTALL TRANSMISSION REVOLUTION SENSOR (NIN)

a.

Apply Toyota Genuine CVT fluid FE to a new O-ring.


b.

Install the O-ring to the transmission revolution sensor (NIN).


c.

Install the transmission revolution sensor (NIN) to the continuously variable transaxle assembly with the bolt.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


d.

Connect the connector.


Hide 74404A 4.INSTALL BATTERY CLAMP SUB-ASSEMBLY

Hide 6.INSTALL AIR CLEANER CASE SUB-ASSEMBLY

Hide 17705 7.INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE

Hide 17751 8.INSTALL NO. 1 AIR CLEANER INLET

Hide 53141F 9.INSTALL RADIATOR COVER

Hide 28800 10.INSTALL BATTERY

Hide 11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Click hereGeneral>MAINTENANCE>3ZR-FAE BATTERY>INSTALLATION

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION