Before replacing the main body ECU (multiplex network body ECU) or certification ECU (smart key ECU assembly), refer to Service Bulletin.*1
*1: w/ Entry and Start System
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
*1: for TMMT Made
*2: for TMC Made
| Symptom | Suspected Area | Link |
|---|---|---|
| Room light does not illuminate | Bulb | - |
| Harness or connector (Including all light components that are part of the wire harness) | - |
*1: w/ Door ambient illumination light
*2: for LHD
*3: for RHD
| Symptom | Suspected Area | Link |
|---|---|---|
| Glove box light does not illuminate | Glove box light assembly |
|
| Harness or connector | - |
*1: for LHD
*2: for RHD
*1: for LHD
*2: for RHD
*1: w/ Entry and Start System
*2: w/o Entry and Start System
*3: for LHD
*4: for RHD
*5: for TMMT Made
*6: for TMC Made
*1: w/ Door ambient illumination light
*2: w/ Entry and Start System
*3: w/o Entry and Start System
*4: for LHD
*5: for RHD
*1: for LHD
*2: for RHD