Home › Engine / Hybrid System › 8NR-FTS (ENGINE MECHANICAL) › ENGINE UNIT › from 2020.08
RM32H0E _51 Engine / Hybrid System _059498 8NR-FTS ENGINE MECHANICAL _0294292 ENGINE UNIT A

8NR-FTS ENGINE MECHANICAL  ENGINE UNIT  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the engine assembly disassembly/reassembly are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
·

Replacement of camshaft timing gear assembly

·

Replacement of camshaft timing exhaust gear assembly


Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 17201 1.REMOVE TURBOCHARGER SUB-ASSEMBLY

Hide 23250 2.REMOVE FUEL INJECTOR ASSEMBLY

Hide 23818 5.REMOVE FUEL VAPOR FEED PIPE

a.
A351529

Remove the 2 bolts and fuel vapor feed pipe from the cylinder head cover sub-assembly.


Hide 16206 6.REMOVE WATER BY-PASS PIPE SUB-ASSEMBLY

a.
A351531

Remove the water by-pass pipe union bolt and water inlet pipe gasket.


b.

Remove the 3 bolts and water by-pass pipe sub-assembly from the cylinder head sub-assembly.


Hide 29300 7.REMOVE VACUUM PUMP ASSEMBLY

Hide 16261G 8.REMOVE NO. 1 WATER BY-PASS HOSE

a.
A351523

Slide the clip and remove the No. 1 water by-pass hose from the water inlet.


Hide 17163 9.REMOVE NO. 1 HEAT INSULATOR BRACKET

a.
A479334

Remove the 2 bolts and No. 1 heat insulator bracket from the cylinder block sub-assembly.


Hide 10.REMOVE WIRE HARNESS CLAMP BRACKET

a.
A392465

Remove the 3 bolts and 2 wire harness clamp brackets from the cylinder head cover sub-assembly.


b.
A392461

Remove the bolt and wire harness clamp bracket from the cylinder head sub-assembly.


c.
A392462

Remove the 3 bolts and 2 wire harness clamp brackets from the stiffening crankcase assembly.


d.
A392463

Remove the bolt and wire harness clamp brackets from the stiffening crankcase assembly.


e.
A392466

Remove the 2 bolts and wire harness clamp bracket from the timing chain cover assembly.


Hide 43457 11.REMOVE DRIVE SHAFT BEARING BRACKET (for AWD)

a.
A392467

Remove the 3 bolts and drive shaft bearing bracket from the stiffening crankcase assembly.


Hide 12.REMOVE STUD BOLT

a.
A394431

Using an E8 "TORX" socket wrench, remove the 2 stud bolts from the timing chain cover assembly.