Perform "Inspection After Repair" after replacing the ignition coil assembly or fuel injector assembly or Fuel pump assembly.
Click hereEngine / Hybrid System>8NR-FTS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION
1.INSTALL WIRE HARNESS CLAMP BRACKET
Install the wire harness clamp bracket to the timing chain cover assembly with the 2 bolts.
Install the wire harness clamp bracket to the stiffening crankcase assembly with the bolt.
Install the 2 wire harness clamp brackets to the stiffening crankcase assembly with the 3 bolts.
Install the wire harness clamp bracket to the cylinder head sub-assembly with the bolt.
Install the 2 wire harness clamp brackets to the cylinder head cover sub-assembly with the 3 bolts.
43457
2.INSTALL DRIVE SHAFT BEARING BRACKET (for AWD)
Install the drive shaft bearing bracket with the 3 bolts.
3.INSTALL STUD BOLT
Using an E8 "TORX" socket wrench, install the 2 stud bolts to the timing chain cover assembly.
17163
4.INSTALL NO. 1 HEAT INSULATOR BRACKET
Install the No. 1 heat insulator bracket to the cylinder block sub-assembly with the 2 bolts.
16261G
5.INSTALL NO. 1 WATER BY-PASS HOSE
Install the No. 1 water by-pass hose to the water inlet and slide the clip to secure it.
29300
6.INSTALL VACUUM PUMP ASSEMBLY
16206
7.INSTALL WATER BY-PASS PIPE SUB-ASSEMBLY
| *1 | Water By-pass Pipe Union Bolt |
Install a new water inlet pipe gasket and temporarily install the water by-pass pipe sub-assembly to the cylinder head sub-assembly with the water by-pass pipe union bolt and 3 bolts (A).
Tighten the water by-pass pipe union bolt and 3 bolts in the order shown in the illustration.
23818
8.INSTALL FUEL VAPOR FEED PIPE
Install the fuel vapor feed pipe to the cylinder head cover sub-assembly with the 2 bolts.
19500D
9.INSTALL NO. 1 IGNITION COIL
23100X
10.INSTALL FUEL PUMP ASSEMBLY
23250
11.INSTALL FUEL INJECTOR ASSEMBLY
17201
12.INSTALL TURBOCHARGER SUB-ASSEMBLY